Pyle PDWMU105 Bedienungsanleitung

Lies die bedienungsanleitung für Pyle PDWMU105 (2 Seiten) kostenlos online; sie gehört zur Kategorie Mikrofon. Dieses Handbuch wurde von 35 Personen als hilfreich bewertet und erhielt im Schnitt 4.6 Sterne aus 5 Bewertungen. Hast du eine Frage zu Pyle PDWMU105 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

PDWMU105

Professional UHF Handheld Microphone

Pro Audio Wireless Mic Transmitter System

with Adapter Receiver, Selectable Frequency

www.PyleUSA.com

RECEIVER AND TRANSMITTER INTRODUCTION

HOW TO USE?

1. Turn ON/OFF ON switch to , the LED indicator is lit. Then insert the 1/4”(6.3mm) Input Jack into audio input

socket.

2. Install batteries in battery compartment. Make sure the polar is correct.2PCS AA

3. Turn ON the transmitter, the Frequency Display is bright. Then you could use this system.

4. When the receiver is out o battery, please use the rechargeable cable to charge the built-in battery of the

receiver.

Notice:

1. If there is any noise, distortion, dead points when using this system, it may be caused by low battery, please

replace with new battery.

2. After stop using it, please turn the switch to “OFF”.

3. If you don’t use this system for long time, please take out the batteries.

FREQUENCY MATCHING:

If there are multiple sets of products in the same environment, crosstalk may occur (same frequency and ID).

It can be completely solved after matching operation according to the following steps.

1. Turn OFF the transmitter and receiver at the same time.

2. Transmitter: Press and hold switch and Frequency Selection Button at the same time for about 4 ON/OFF

seconds, then the Frequency Display will ash

3. Receiver:Turn ON the power switch of the receiver, then the RF LED indicator ashes four times.

4. Transmitter: Shortly press the Frequency Selectable Button to exit the matching operation.

4

1

2

3

1

2

1. ON/OFF switch

2. Frequency Selection Buttom

3. Frequency Display

4. Battery Compartment

1. ON/OFF sweitch

2. Antenna

3. RF LED indicator

4. DC 5V rechargeable power input

Produktspezifikationen