RDL D-TPS7A Bedienungsanleitung
RDL
Nicht kategorisiert
D-TPS7A
Lies die bedienungsanleitung für RDL D-TPS7A (2 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 23 Personen als hilfreich bewertet und erhielt im Schnitt 3.7 Sterne aus 12 Bewertungen. Hast du eine Frage zu RDL D-TPS7A oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/2
Twisted Pair Format-A
Modules D-TPS7A & D-TPP7A
Modules DS-TPS7A & DS-TPP7A
Format-A Passive Single Pair Sender
RDL
659 6
th
St.
Prescott, AZ., USA 86301
(928) 443-9391
FAX (928) 443-9392
www.rdlnet.com
Stereo Audio Input Combined to Mono Output
Input on Mini-jack
Switch Selects which RJ45 Pair (A, B or C) is Fed
Signal and Power Pair Pass-Through between TP CABLE RJ45 Jacks
Passive Circuitry Does Not Require Power
Galvanic Isolation through a Studio-Quality Transformer
Daisy-Chain with Single-Pair or Two-Pair Format-A Senders
The -TPS7A is a single-pair audio sending module compatible with RDL
®
Format-A twisted pair products. The front panel
features a single stereo mini-jack intended for stereo consumer line level audio sources. A studio-quality transformer
provides isolation between the audio source and the RJ45 TP CABLE.
The -TPS7A is a single-pair sender, feeding the input signal to the cable pair set on the rear-panel
switch during installation. This module drives only one cable pair, therefore a TP CABLE RJ45 jack is
provided to accept signals and power from other mic-level or line-level Format-A senders. Two other
single-pair senders may be chained to a TP CABLE jack, or a single two-pair sender may be
connected. If three single-pair senders are connected together, each sender must feed a different
pair: A, B or C. The -TPS7A must be set to feed pair A if it is connected together with an RDL two-pair
sender that feeds stereo audio on pairs B and C.
The -TPS7A is a passive module that does not require power to operate. If power is present on a
cable connected to a TP CABLE jack, that power is passed through to the modules connected to the
other TP CABLE jack.
The D-TPP7A is the same as the D-TPS7A but includes a connection for composite video pass through.
D-TPS7A or DS-TP76A Format-A Audio Sender
Video Monitor Pass-Through
Available in RDL White/Gray (D-TPP7A)
Available in Stainless Steel (DS-TPP7A)
D-TPS7A
DS-TPS7A DS-TPP7A D-TPP7A
STEP 1: Set the PAIR selector so the module is driving the desired pair A, B or C of the Format-A cable. If the module is connected
together with one or two other single-pair senders, each sender must be set to a different pair. If connected together with a
two-pair
sender, the switch must be set to pair A.
STEP 2: Connect a high-impedance unbalanced audio source to the input (-10 dBu 3.5 mm mini-jack).
STEP 3: Connect the twisted pair cable(s) and mount the module.
TWISTED PAIR Format-A
Model D-TPS7A & D-TPP7A
Model DS-TPS7A & DS-TPP7A
Format-A Passive Single-Pair Sender
Installation/Operation
Declaration of Conformity available from rdlnet.com.
Sole EMC specifications provided on product package.
Specifications are subject to change without notice.
Radio Design Labs Technical Support Centers
U.S.A. (800) 933-1780, (928) 778-3554; Fax: (928) 778-3506
Europe [NH Amsterdam] (++31) 20-6238 983; Fax: (++31) 20-6225-287
891-4645A
TYPICAL PERFORMANCE
Input: 3.5mm mini-jack, unbalanced stereo combined to mono
Input Level: -10 dBV, +22 dBu max
Format-A Signal Pair Used: Switch-selectable A, B, or C (rear-panel switch)
Format-A Input: RJ45 TP CABLE
Output: RJ45 TP CABLE, RDL TP Format-A
Frequency Response: 20 Hz to 20 kHz (±0.5 dB)
THD: < 0.1% (50 Hz to 20 kHz); <0.001% (1 kHz typ)
Power Requirement: Passive
Dimensions: 1.6” (4.06 cm) W; 4.11” (10.45 cm) H; 1.89” (4.8 cm) D
(1) + White / Green
(2) – Green
(3) + White / Orange
(4) – Blue
(5) + White / Blue
(6) – Orange
(7) + White / Brown
(8) – Brown
Pair A: Audio +4 dBu
Pair B: Audio +4 dBu
Pair C: Audio +4 dBu
Pair D: Power +24 Vdc
Tab on bottom of connector
RJ45 Standard wiring
RJ45 conductor colors shown are for 568A standard. The 568B standard may be used if the connectors at both ends of the cable are wired identically.
Produktspezifikationen
| Marke: | RDL |
| Kategorie: | Nicht kategorisiert |
| Modell: | D-TPS7A |
Brauchst du Hilfe?
Wenn Sie Hilfe mit RDL D-TPS7A benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert RDL
2 September 2024
29 August 2024
29 August 2024
26 August 2024
18 August 2024
27 Juli 2024
21 September 2023
19 September 2023
29 August 2023
13 November 2022
Bedienungsanleitung Nicht kategorisiert
- Nils
- Teia
- One Stop Systems
- IFootage
- Hohem
- Minn Kota
- Phidgets
- UGo
- Luminex
- Vileda
- Envertec
- Virax
- Thermador
- Cartoni
- Yamato
Neueste Bedienungsanleitung für -Kategorien-
1 August 2025
1 August 2025
1 August 2025
1 August 2025
1 August 2025
1 August 2025
1 August 2025
1 August 2025
1 August 2025
1 August 2025