RP Lighting & Fans BVF50 Bedienungsanleitung

Lies die bedienungsanleitung für RP Lighting & Fans BVF50 (2 Seiten) kostenlos online; sie gehört zur Kategorie Dunstabzugshaube. Dieses Handbuch wurde von 4 Personen als hilfreich bewertet und erhielt im Schnitt 4.5 Sterne aus 2 Bewertungen. Hast du eine Frage zu RP Lighting & Fans BVF50 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

BATH VENTILATION FAN

MODEL:

BVF50 BVF70

1

WARNING

READ AND SAVE THESE INSTRUCTIONS

Installer: Leave this manual with the homeowner.

CAUTION

CLEANING & MAINTENANCE

OPERATION

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR PERSONAL INJURY, OBSERVE

THE FOLLOWING:

•Use this unit only in the manner intended by the manufacturer. If you have questions, contact

the manufacturer at the address or telephone number listed in the warranty.

•Before servicing or cleaning the unit, switch the power off at the servic

e panel. If possible, lock

out the switch. If the switch cannot be locked, securely fasten a prominent warning device,

such as a tag, to the service panel.

•

Installation work and electrical wiring must be performed by a qualified person(s) in accordance

with all applicable codes and standards, including fire-rated construction codes and standards.

•

Sufficient air is needed for proper combustion and exhausting of gases through the flue

(chimney). Proper venting is essential to expel gases safely and prevent backdrafting. Follow

the heating equipment manufactur

er’s guideline and safety standards such as those

published

by the National Fire Protection Association (NFPA), and the American Society for Heating,

Refrigeration, and Air Conditioning Engineers (ASHRAE), and the local code authorities.

•

When cutting or drilling into the wall or ceiling, do not damage electrical wiring and other hidden

utilities.

•Ducted fans must always be vented to the outdoors.

•

Acceptable for use over a tub or shower when connected to a GFCI (Ground Fault Circuit

Interrupter) protected branch circuit.

•This unit must be grounded.

•For general ventilating use only. Do not use to exhaust hazardous or explosive materials and

vapors.

•

This product is designed for installation in ceilings that have up to a 12/12 pitch (45 degree

angle). The duct connector must point up.

•

To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray,

construction dust, and other contaminants out of power unit.

•Please read the specification label on the product for further information and requirements.

•Do not use in a cooking area.

Use an on/off switch to operate this fan. See “Connect Electrical Wiring” for details.

For quiet and efficient operation, long life, and an attractive appearance, lower or remove the grille

and vacuum the interior of the unit with a dusting brush attachment.

The motor is permanently lubricated and never needs oiling. If the motor bearings make excessive or

unusual noise(s), replace the motor with the same motor. The impeller should also be replaced.

Produktspezifikationen