Savage Promo Background Stand Bedienungsanleitung

Lies die bedienungsanleitung für Savage Promo Background Stand (1 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 17 Personen als hilfreich bewertet und erhielt im Schnitt 4.3 Sterne aus 9 Bewertungen. Hast du eine Frage zu Savage Promo Background Stand oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

CONTENTS

(2) T-Legs

(2) Telescoping uprights

(4) Crossbar sections

(2) Crossbar connectors

(2) Allen head screws

(1) Allen wrench

(1) Carry bag

4) ATTACHING TOP CROSSBAR TO UPRIGHT

Unscrew the knurled knob on the end of

each crossbar section until the screw is

completely unthreaded.

Slide the threaded knob through

the hole nearest the top of the upright.

Thread one side of the crossbar into the

threaded knob until tight.

REPEAT ON SECOND UPRIGHT ON OPPOSITE SIDE

1) ASSEMBLING T-LEG BASE

Slide telescoping upright stand section through the hole located

on top of the T Leg. Use the included allen wrench to tighten the

upright using the included Allen head screw.

REPEAT TO ATTACH SECOND UPRIGHT TO THE SECOND T LEG

2) ASSEMBLING UPRIGHTS

Extend the upright section nearest the

top 6" and tighten for both uprights.

3) ASSEMBLING CROSSBARS

Connect the 2 sections of both crossbar sets

using the silver crossbar connectors,

making sure that the pin on the

connector is lined up with the

hole on each crossbar

section.

Push together until the silver pin

snaps into the hole on the

crossbar.

5) RAISING UPRIGHTS

Raiser the lowest section of the up

right stand on both sides and

re-tighten.

RAISE UPRIGHT LOWER SECTIONS 6”THE CROSSBAR WILL NOT ATTACH THROUGH THE

DRILLED HOLES IF THE UPRIGHT IS ALL THE WAY DOWN

Assembly & Usage

Instructions

PROMO

BACKGROUND STAND

WWW.SAVAGEUNIVERSAL.COM

6) ATTACHING LOWER CROSSBAR TO UPRIGHT

Repeat Step 4 to connect the second

crossbar to the upright stands using the

drilled holes located at the bottom of

the lowest upright stand section.

Be sure to raise the lowest

section of the upright

6" before attempting

to connect the

crossbar.

USE OF SAVAGE PROMO STAND

Telescoping crossbars can be adjusted to accommodate backdrops or banners

as small as 6’ wide up to 9’ 8” wide. Telescoping upright stands can be adjusted

from 40” tall up to 8’ tall. Detach one side of top crossbar from the upright stand

to slide on backdrops that have a sewn-in pole pocket or simply secure the

material to the crossbar using standard clamps. To pull out wrinkles from the

backdrop or banner, clamp the bottom edge of the material to the bottom

crossbar with clamps. This support stand is an especially ideal system for cloth

backgrounds.

Produktspezifikationen