Skan Holz Venlo Bedienungsanleitung
Skan Holz
Nicht kategorisiert
Venlo
Lies die bedienungsanleitung für Skan Holz Venlo (19 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 4 Personen als hilfreich bewertet und erhielt im Schnitt 5.0 Sterne aus 2.5 Bewertungen. Hast du eine Frage zu Skan Holz Venlo oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/19
© SKAN HOLZ Europe GmbH D-21227 Bendestorf. Technical modifications reserved. All dimensions are approximate dimensions. Date 06/18
Venlo 1 250 x 250cm
603206 (unbehandelt)
603206-13 (schiefergrau)
603206-15 (schwedenrot)
1
Important information
We are pleased that you have chosen a product of SKAN HOLZ.
Please check the construction set for completeness using the position list in good time before starting con-
struction or commissioning your construction team. If individual parts are defective or missing, we will deliver
these as quickly as possible. However, we cannot refund the costs for any resulting construction delays to a
construction company.
Please understand that we cannot assume any guarantee for the following defects:
- incorrect storage before assembly
- incorrect anchoring with the ground or inadequate foundation (foundation according to statics)
- damage due to erection errors, e. g. the house is not level or not right-angled
- damage through a higher level of snow burden than statically envisaged. Recommendation: lad relief of
the roof by removing the snow layer
- storm damage (insurance cases) or violent destruction
- damage through any alteration to the design by the client
- natural formation of cracks, branch holes, twisting, decolouration or similar modification (natural
process; has no influence on the statics)
Storage information until construction:
- store pallet on a level and dry surface.
- ; wood can warp drastically in a looseProtect from exposure to sunlight and the influences of weather
condition!
Maintenance tips:
Please observe the attached information sheet “Care instructions/Colour treatment”.
General tips and refers to:
The packaging foil to keep moisture out of the house. It is laid according to the ground area of thecan be used
house under the main bearing.
As the house is exposed constantly to the weather, it is necessary to lay a further welding line. You have to make
it for your own.
A possibly desired installation of a rain gutter must be done by the building contractor; for this the roofing boards
must be cut to the right length.
Foundation according to the structural calculations (not included in the scope of delivery): concrete C25/30,
each 2 Ø 12 top and bottom, brace mat R188A (alternatively brace Ø 6/20cm). Anchoring of the floor beams
(in the building) on the strip foundation using bolts M12, e < 60cm. The base bearings in the storeroom of the
house must be entirely flush.
During the assembly of the planks that the planks are fixed with approx. it is essential to make sure 1mm
distance and the top planks have the same height all around.
Due to storage, the measurements of the planks may change over time and change the heigth of the wallplanks.
Please remember this during the installation of the planks, otherwise it may result in different wall heights.
If the door , this can be adjusted by .cannot be closed properly turning the hinges
The roofing boards are laid out up to the inner edge of the outer facing. The final roofing board must be adjusted
in width. The roofing boards must be cut out as necessary in the area near the fastening wood H16/58-00 (34cm).
It is planned to have the roofing paper go up the sides over the existing gap as high as the facing, and to attach it
there on the facing. The building contractor can also lay strips over the gap, or the roofing paper can be laid right
up to the upper edge of the facing; this will then be covered by the aluminium strip A100-220.
-
-
-
-
-
-
-
-
1
1
2
2
3
5
3
4
250 x 250cm
1 x H28/140-00
18cm
1 x 28-29-004
283cm
6 x H16/58-00
219cm
3 x H16/58-00
231,4cm
2 x H16/58-00
245cm
2 x H16/58-0
278,4cm
2 x H16/58-00
281,6cm
6 x H19/119-01
290cm
2 x H30/33-00
34cm
3 x H28/140-00
16,5cm
8 x H12/40-00
250cm
© SKAN HOLZ Europe GmbH, D-21227 Bendestorf. Stand 06/18
1 x H20/46-00
123,4cm
4 x H58/
249,5
22 x H19/121-01
243,5cm
5 x H20/20-04
200cm
27 x H19/119-01
135cm
27 x H19/119-01
143,5cm
603
603
603
250 x 250cm
4
1 x 28-10-0010
1 x 28-10-0011
1 x 28-10-0009
16 x 28-06-0036
1 x 28-06-0042
16 x 28-06-0034
1 x 28-06-0042
1 x 28-06-0043
1 x 28-06-0034
30 x 28-06-0035
© SKAN HOLZ Europe GmbH, D-21227 Bendestorf. Stand 06/18
1 x 28-10-0010
1 x 28-10-0011
1 x 28-10-0009
16 x 28-06-0036
603206 (unbehandelt)
603206-13 (schiefergrau)
603206-15 (schwedenrot)
Produktspezifikationen
| Marke: | Skan Holz |
| Kategorie: | Nicht kategorisiert |
| Modell: | Venlo |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Skan Holz Venlo benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Skan Holz
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025
10 Juli 2025
10 Juli 2025
10 Juli 2025
10 Juli 2025
10 Juli 2025
10 Juli 2025
Bedienungsanleitung Nicht kategorisiert
- Mermade Hair
- ZyXEL
- Velux
- Socomec
- AudioQuest
- Projecta
- Jupiter
- Sanus Systems
- AEG
- Edge Products
- Newgen Medicals
- Woodland Scenics
- Topping
- Asrock
- Atlantis Land
Neueste Bedienungsanleitung für -Kategorien-
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025