Smeg CPF9GMWH1 Bedienungsanleitung

Lies die bedienungsanleitung für Smeg CPF9GMWH1 (5 Seiten) kostenlos online; sie gehört zur Kategorie Herde. Dieses Handbuch wurde von 24 Personen als hilfreich bewertet und erhielt im Schnitt 4.4 Sterne aus 12.5 Bewertungen. Hast du eine Frage zu Smeg CPF9GMWH1 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Instructions

EN

READ BEFORE USE

IMPORTANT INSTRUCTIONS

Only for South Africa

Additional installation information for

SMEG gas hobs and stoves supplied to

South Africa

All Smeg appliances comply with SANS

1539 and have been issued with Permit

numbers by the Liquefied Petroleum Gas

Safety Association of Southern Africa.

Gas Type: LPG (Note: This appliance may

have been supplied ex factory with setting

and jets for Natural Gas. Your installer must

make the necessary changes and

adjustments before handing over the

installed appliances for use).

Operating Pressure: 2.8 kPa. Note that this

appliance may only be used with a LPG

regulator of 2.8 kPa outlet pressure and that

complies with requirements of SABS 1237.

• This appliance may only be installed by

a registered LPGas Practitioner/Installer.

All registered Gas fitters are provided

with an identity card, which also carries

their registration number. Make a note of

this. The LPGas Practitioner/Installer

should also provide you with a written

certificate after completing the work.

Before the installer hands over the

installed appliance ensure that you are

informed of the location of the isolation

or shut off valve in the gas supply line to

the appliance and how to operate it.

• Do not modify the appliance in any way

as this may make it unsafe.

• Note carefully the ventilation

requirements indicated in the specific

model instruction booklet. This

information is vital for the safety of the

occupants of the area in which the

appliance is installed and used.

• Never check for gas leaks with a naked

flame. Always use a soapy water

solution applied with a brush to the areas

where you suspect there may be a gas

leak. Do not use the appliance if you

suspect a gas leak.

• There are no preset service intervals for

this appliance. Refer to the section on

maintenance and cleaning in the

instruction booklet for details on how to

care for your SMEG appliance.

• After removing burner caps or burner

heads to clean them or the hob surface

around the burners, always take care

that the burner heads are properly

located in position and that the igniter

post and flame failure thermocouple are

not damaged in any way. It is important

that these devices fit correctly into the

location holes provided in the burner

heads. They will not function correctly if

not properly located. The burner caps

locate by means of the ridge on the

underside. Note that burners will not

work efficiently if the burner caps are not

properly located. There are drawings of

a typical burner assembly in your

instruction booklet.

Produktspezifikationen