Snow Joe SJBLZD-LED Bedienungsanleitung

Lies die bedienungsanleitung für Snow Joe SJBLZD-LED (8 Seiten) kostenlos online; sie gehört zur Kategorie Besen. Dieses Handbuch wurde von 80 Personen als hilfreich bewertet. Hast du eine Frage zu Snow Joe SJBLZD-LED oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

/ 8 PDF

1

A Division of Snow Joe®, LLCSJBLZD-LED Form No. SJ-SJBLZD-LED-880E-MR1

OPERATOR’S MANUAL

LED LIGHTED 4-IN-1 ICE SCRAPER +

SNOW BROOM

© 2020 by Snow Joe®, LLC

All rights reserved. Original instructions.SAVE THESE INSTRUCTIONS

R

If you have any questions or comments, please call the Snow Joe® + Sun Joe®Customer Service

department at: 1-866-SNOWJOE (1-866-766-9563)

C

L

O

S

E

O

P

E

N

A.

B. C. D.

mBattery Caution + Disposal Information

1. Batteries vary according to device. Use the correct size and type of battery specied by the manufacturer of

your device.

2. Install only new batteries of the same type in your product (where applicable).

3. Failure to insert batteries in the correct polarity, as indicated in the battery compartment or manual, may shorten

the life of the batteries or cause batteries to leak.

4. Do not mix old and new batteries.

5. Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium, Nickel Metal Hydride,

or Lithium-Ion) batteries.

6. Do not dispose of batteries in re.

7. Batteries should be recycled or disposed of as per state and local guidelines.

Battery Installation + Operation

1. Make sure the unit is turned o and switch is in center position.

2. Locate battery compartment on the back panel of illum-n-broom. Loosen and remove

battery cover using a coin or slotted screwdriver. Your hand works pretty good, too.

NOTE: The battery compartment cover must be properly aligned to maintain a

watertight seal, and for easy removal later. To reinstall and properly realign the cover

threads, rst place the broom head on a at surface. Next, twist the cover two full

turns to the left, then twist right until tight.

3. Insert two AAA batteries as indicated in the battery compartment, ensuring proper

alignment.

4. Close battery compartment door and tighten to ensure watertight seal. Do not over-tighten.

NOTE: Slide on/o switch right to activate lights. Slide switch left to activate safety blinkers.

Attaching the Pole

A. Secure handle to head.

B. Twist pole to loosen.

C.Extend to desired length.

D. Twist to lock.

EN

Produktspezifikationen