Soundsphere SS-Q-8 Bedienungsanleitung

Lies die bedienungsanleitung für Soundsphere SS-Q-8 (2 Seiten) kostenlos online; sie gehört zur Kategorie Lautsprecher. Dieses Handbuch wurde von 27 Personen als hilfreich bewertet und erhielt im Schnitt 4.0 Sterne aus 14 Bewertungen. Hast du eine Frage zu Soundsphere SS-Q-8 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

SS-Q-8

OWNER’S MANUAL

© 2021 MSE Audio. Rev. 02.25.2021

360º of the Best Sound Around™

Contact: MSE Audio, 855.663.5600 / 913.663.5600 / [email protected]

Please read the following instructions carefully before installing

your Soundsphere

®

speaker. If you have any questions

regarding installation that are not answered in the following

directions, please contact your local sound contractor or the

Soundsphere

®

/MSE Audio

®

technical support team.

General Information

Maximum Amplier Power 100 Watts RMS

Nominal Impendance 8 ohms

Wiring

Amplier connection is via ying leads. Connect the positive

(+) amplier lead to the RED input wire. Connect the negative

(-) amplier lead to the BLACK wire. Secure connections us-

ing wire nuts, etc. For wiring optional 100W transformer, see

section “TX-100 Transformer Installation Instructions” on page

2 of this manual.

Mounting

Hanging Kit

Mount using one of the following methods:

a) Properly secured wire rope with a minimum breaking

strength of 225 lbs. (for a 10:1 safety factor).

b) Beam clamp with proper load rating.

It is recommended to use a secondary wire rope support around

one of the Q-8 legs. Do not use rope for mounting. The use of

chain is not recommended unless rated for suspension of loads

greater than or equal to 225 lbs (for a 10:1 safety factor).

Surface Mount Bracket

Secure the bracket to the hard surface using proper hardware.

Secure the Q-8 to the bracket using the washers and nylon

locknuts provided. It is recommended to use a secondary wire

rope support around one of the Q-8 legs and through an unused

bracket hole.

Warranty

Soundsphere loudspeakers carry a 5 year limited warranty and

a 3 year limited warranty on all electrical components. See war-

ranty sheet for details and limitations.

Replacement Parts

8” 100 Watt coaxial loudspeaker driver with crossover.

- Order Model Number CX-8

Always check local requirements for overhead suspension

of loudspeakers.

Replacing the Coax Driver and Crossover in the Q-8

1. Remove the reector from the Q-8 by removing the 3

bolts, washers, and tabs.

2. Remove the 4 screws securing the driver. Remove the

driver by gently lifting the tweeter with one hand and

removing it with the other hand. Pull the wire out through

the hole in the bolt.

3. Feed the wire from the replacement driver through the

drilled bolt inside the sphere. Install the new driver and

secure with screws.

Other Information

Wire runs between the amplier(s) and loudspeaker(s) must be

of the appropriate gauge to insure the full audio performance

capabilities of the Soundsphere loudspeakers. This applies

to all loudspeaker impedances (4 or 8 Ohms) or audio line

voltages (50, 70.7 or 100 Volts). For more information, please

see the ‘Downloads” section at www.soundsphere.com, or call

our Customer Service at 913.663.5600.

Leg Bolt

Tab

Metal Washer

Rubber Washer

Reector

Rubber Washer

Metal Washer

Leg

Produktspezifikationen