Speco Technologies O4VLD1 Bedienungsanleitung
Lies die bedienungsanleitung für Speco Technologies O4VLD1 (11 Seiten) kostenlos online; sie gehört zur Kategorie Überwachungskamera. Dieses Handbuch wurde von 19 Personen als hilfreich bewertet und erhielt im Schnitt 4.8 Sterne aus 10 Bewertungen. Hast du eine Frage zu Speco Technologies O4VLD1 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/11
Quick Start Guide
4MP IP Vandal Dome Camera
O4VLD1
Version 1.0
i
Welcome
Thank you for purchasing this network camera!
This manual is designed to be a reference tool for your system. owner’s
Please read this manual carefully before operang the unit and retain it for future reference.
Should you require any technical assistance, please contact Speco Technologies Technical Support.
ii
Important Safeguards and Warnings
1 Electrical safety
．
．
．
．．
All installaon and operation here should conform to local electrical safety codes.
Use a certied/listed 12VDC Class 2 power supply only.
Please note: Do not connect two power supplying sources to the device at the same me; it may result in
device damage! The product must be grounded to reduce the risk of electric shock.
Improper handling and/or installaon could run the risk of re or electrical shock.
2 Environment
．
．
．
．．
Heavy stress, violent vibraon or exposure to water is not allowed during transportaon, storage and
installation.
This product should be installed in a cool, dry place away from direct sunlight and heat sources.
Do not install the product in extreme temperature conditions.
Do not expose the camera to electromagnec radiaon. Otherwise it may result in CMOS sensor failure.
Do not block any venlation openings.
Do not allow water and liquid intrusion into the camera.
3. Operaon and Daily Maintenance
Please shut down the device and then unplug the power cable before you begin any maintenance work.
Do not touch the CMOS sensor opc component. You can use a blower to clean the dust on the lens surface.
Always use the dry so cloth to clean the device. If there is too much dust, use a cloth dampened with a small
quanty of neutral detergent. Finally use the dry cloth to clean the device.
Please use a professional opcal cleaning method to clean the enclosure. Improper enclosure cleaning (such as
using cloth) may result in poor IR functionality and/or IR reecon.
The grounding holes of the product are recommended to be grounded to further enhance the reliability of the
camera.
Dome cover is an opcal device, please don’t touch or wipe cover surface directly during installaon and use,
please refer to the following methods dirt is found: if
Stained with dirt
Use oil-free so brush or hair dryer to remove it gently.
Stained with grease or ngerprint
Use oil-free coon cloth or paper soaked with alcohol or detergent to wipe from the lens center outward.
Change the cloth and wipe several mes if it is not clean enough.
Warning
This camera should be installed by qualied personnel only.
All the examinaon and repair work should be done by qualied personnel.
Any unauthorized changes or modicaons could void the warranty.
Produktspezifikationen
| Marke: | Speco Technologies |
| Kategorie: | Überwachungskamera |
| Modell: | O4VLD1 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Speco Technologies O4VLD1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Überwachungskamera Speco Technologies
3 September 2024
19 August 2024
18 August 2024
18 August 2024
17 August 2024
17 August 2024
17 August 2024
16 August 2024
16 August 2024
Bedienungsanleitung Überwachungskamera
- Alecto
- Honeywell
- CNB Technology
- Milesight
- Philips
- Brilliant
- ACTi
- DVDO
- Securetech
- Conbrov
- Seneca
- Spyclops
- IC Intracom
- Belkin
- Adesso
Neueste Bedienungsanleitung für -Kategorien-
15 Oktober 2024
15 Oktober 2024
14 Oktober 2024
14 Oktober 2024
13 Oktober 2024
13 Oktober 2024
13 Oktober 2024
11 Oktober 2024
11 Oktober 2024
11 Oktober 2024