Star Micronics TUP900 Bedienungsanleitung

Lies die bedienungsanleitung für Star Micronics TUP900 (1 Seiten) kostenlos online; sie gehört zur Kategorie Drucker. Dieses Handbuch wurde von 18 Personen als hilfreich bewertet und erhielt im Schnitt 4.7 Sterne aus 9 Bewertungen. Hast du eine Frage zu Star Micronics TUP900 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

1

2

1

2

Attaching the Shaft and Adjusting the Loop Guide

In order to have a Stable Paper Feed, it may be necessary to attached the Shaft Weight and adjust the Loop Guide.

•Paper Thickness: Minimum 0.065 to Maximum 0.10 mm.

1)The Shaft Weight is not used, therefore attach it to the storage position #3 as per g. 2.

2)It is possible, due to sudden environmental changes, that a deformation of the Loop Guide may occur (see Fig. 3), to

remove the deformation, reposition the Loop Guide by :

Loosening the retaining screw next to position A (Fig. 4).

Move the Loop Guide in the direction of the arrow (Fig. 4).

Tighten the retaining screw while ensuring the deformation has been removed.

•

Paper Thickness: Minimum 0.10 to Maximum 0.15 mm.

Fit the Shaft Weight into the Shaft Hooks at Position #1 (Fig. 2).

Remove the Loop Guide (and store it for use) by removing the two retaining screw’s (Fig. 4).

The Shaft Weight may be adjusted to Position #2 dependent on the length / thickness of the recording paper and the

environmental conditions.

80871340 TUP900

Position #1

Position #2

Position #3

Shaft Hooks

Loop Guide

Shaft Weight

Loop GuideScrew

Position A

Screw

Figure 3Figure 4

Figure 1Figure 2

Cutter

Loop Guide

Deformation

Produktspezifikationen