Sun Joe 24V-CTLR-LTE Bedienungsanleitung


Lies die bedienungsanleitung für Sun Joe 24V-CTLR-LTE (16 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 4 Personen als hilfreich bewertet und erhielt im Schnitt 4.3 Sterne aus 2.5 Bewertungen. Hast du eine Frage zu Sun Joe 24V-CTLR-LTE oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Seite 1/16
OPERATOR’S MANUAL
Model 24V-CTLR-LTE
Form No. SJ-24V-CTLR-LTE-880E-M-FTY
CORDLESS CLAW TILLER + CULTIVATOR
24V* IONMAX | 2.0 Ah | 3.6-INCH
1
R
A Division of Snow Joe, LLC
*DISCLAIMER: Initial no-load voltage, when fully charged,
SAVE THESE INSTRUCTIONS
Original instructions.
© 2023 Snow Joe, LLC. All rights reserved.
IMPORTANT!
Safety Instructions
All Operators Must Read These
Instructions Before Use
Always follow these safety guidelines. Failure to do so may result
in serious bodily injury or death.
General Safety WARNINGS!
You and any other operator of this cordless claw tiller +
cultivator must read, understand, and follow these instructions
in their entirety. Failure to follow these instructions may result in
ELECTRIC SHOCK, FIRE, and/or serious PERSONAL INJURY.
Notice the personal safety alert symbol
m used in this
manual to draw your attention to a WARNING given along
with the particular operating instruction. This means that
the operation requires special ATTENTION, CAUTION, and
AWARENESS.
1. Keep work area clean and well-lit – Cluttered, dark areas
invite accidents.
2. Replacement parts – When servicing this unit, use only
identical replacement parts. Replace or repair damaged
parts immediately.
3. Keep children, bystanders, and pets away –
All spectators, including pets, should be kept a safe distance
away from the work area.
4. Know your product – Know how to start and stop the
machine. Be thoroughly familiar with the controls.
5. Use the right tool – Do not use this machine for any job
except that for which it was intended.
6. Dress properly – Do not wear loose clothing or jewelry as
such articles can become caught in moving parts.
Wear a protective covering to contain long hair.
Wearing rubber gloves and substantial non-slip footwear is
recommended when working outdoors.
7. Avoid accidental starting – Do not carry the cordless claw
tiller + cultivator with your finger on the switch.
mCAUTION! Moving parts will continue to run for several
seconds after turning off the machine.
8. Moving parts – Keep hands and feet away from moving
parts. Keep guards in place and in proper working order.
9. Do not force the tool – It will perform better with less
likelihood of personal or mechanical injury if it is used at the
rate for which it was designed.
10. Do not overreach – Keep proper footing and balance at all
times.
11. If the cordless claw tiller + cultivator strikes a foreign
object, follow these steps:
• Stop the cordless claw tiller + cultivator.
• Inspect for damage.
• Repair any damage before restarting and
operating the tool.
12. Use safety glasses – Also use safety footwear,
snug-fitting clothing, protective gloves, hearing, and head
protection.
13. Remove the battery – Remove the battery from the cordless
claw tiller + cultivator when it is not in use,
before servicing it, when changing accessories,
and when performing any other maintenance task.
14. Store idle tool indoors – When not in use, the cordless
claw tiller + cultivator should be stored indoors in a dry and
high or locked-up place out of the reach of children.
15. Maintain the cordless claw tiller + cultivator with
care – Keep the cutting edges sharp and clean for optimal
performance and to reduce the risk of injury.
Keep the handles dry, clean, and free from oil and grease.
Follow the additional recommendations described in the
maintenance section of this manual.
16. Avoid dangerous environments – Do not use the cordless
claw tiller + cultivator in rain or in damp or wet locations. Do
not operate the cordless claw tiller + cultivator in gaseous
or explosive atmospheres or use the cordless claw tiller +
cultivator near flammable or combustible liquids. Motors
in these tools normally spark, and the sparks might ignite
fumes.
17. Stay alert – Watch what you are doing. Use common sense.
Do not operate the cordless claw tiller + cultivator when you
are tired or under the influence of drugs, alcohol, or other
medication.
2
18. Check for damaged parts – Before further use of the
appliance, a guard or other part that is damaged should be
carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts,
mounting, and any other condition that may affect its
operation. A guard or other part that is damaged should be
properly repaired or replaced. Contact the Snow Joe
®
+
Sun Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563) for assistance.
Training
• Read, understand, and follow all instructions on the cordless
claw tiller + cultivator and in the manual before operating this
unit. Thoroughly familiarize yourself with the controls and the
proper use of the equipment. Know how to stop the unit and
disengage the controls quickly.
• Children should never be allowed access to the equipment.
Adults should never operate the equipment without carefully
reading and understanding these instructions.
• Keep the area of operation clear of all persons,
particularly children or pets.
• Exercise caution to avoid slipping or falling.
• Always plan your cultivating path to avoid discharge of
material toward people, pets, and property (e.g. windows,
cars, etc.). Thrown objects can cause serious personal injury
and property damage. Do not allow anyone in front of a
running machine.
• Keep people, pets, and property at least 25 feet from the
cordless claw tiller + cultivator while it is in operation.
Stop the cordless claw tiller + cultivator if people or pets
enter the discharge area.
• Always observe the surface conditions in order to avoid
slipping, falling, and unexpected objects.
Preparation
• Always inspect the area where the cordless claw tiller +
cultivator is to be used. Remove all objects (i.e. stones,
sticks, wires, and other foreign materials) that could be
thrown by the blades or cause the operator to trip.
• Thrown objects can cause serious injury to the eyes and
exposed body. Always wear safety glasses or eye shields
during operation and while making an adjustment or repair.
• Always operate the cordless claw tiller + cultivator wearing
adequate garments. Do not wear jewelry or other loose
clothing, which could become entangled in moving parts.
Wear non-slip footwear to ensure proper footing.
• Observe any noise-prevention regulations and laws.
• Inspect the cordless claw tiller + cultivator for worn, missing,
or damaged parts and safety labels. See maintenance
section for detailed instructions.
Operation
• Do not operate the machine while under the influence of
alcohol or drugs.
• Keep all safety devices in place and in proper working order.
Do not operate with missing or damaged components.
• Ensure the controls (start/stop) function properly before
cultivating.
• Hold onto the cordless claw tiller + cultivator with both hands
during operation. Ensure the grips are dry.
• Contact with rotating parts can amputate hands and feet.
Keep hands and feet away from all rotating parts.
• Only operate the cordless claw tiller + cultivator when there
is good visibility or light and dry conditions. Always watch
your footing and keep a firm hold on the grips. Walk; don't
run!
• Do not operate the cordless claw tiller + cultivator on
slippery surfaces. Check your footing during use.
• Exercise caution when changing direction and operating the
tool on slopes. Always keep feet and legs a safe distance away
from the machine. Look for hidden obstacles or hazards.
• Do not overload machine capacity by attempting to cultivate
too deeply. It will cause excessive resistance.
• Stop the cordless claw tiller + cultivator and remove the
battery before leaving the operating position (behind the
handles) to adjust or inspect the unit. Wait until the blades
have come to a complete stop.
• If the cordless claw tiller + cultivator should start to vibrate
abnormally, stop the machine and inspect thoroughly for
damage.
• Turn the machine OFF when moving to a new work area.
Allow the blades to completely stop rotating before
transporting the unit.
• Always use proper care and good judgment when you are
confronted with a situation that is not covered in this manual. If
you are unsure of what to do, contact your authorized
Snow Joe
®
+ Sun Joe
®
dealer or call the Snow Joe
®
+ Sun Joe
®
customer service center at 1-866-SNOWJOE (1-866-766-9563).
• Do not use in rain or wet conditions.
• Do not grasp the exposed cutting blades or cutting edges
when picking up or holding the appliance.
Stopping Work
• Always turn the cordless claw tiller + cultivator OFF and
remove the battery when stopping work or when changing
work areas. Never leave the machine running when
unattended.
• The blades will continue to rotate for a short period after
turning OFF the cordless claw tiller + cultivator. Wait until the
blades have completely stopped before lifting the machine or
conducting inspection and maintenance.
• The motor housing remains hot for a short period after the
machine is turned OFF. Allow the motor housing to cool
completely before touching or storing near combustible
material.
3
Maintenance + Storage
• Maintain or replace safety and instruction labels.
• Disengage all controls, stop the engine, and wait until the
blades come to a complete stop before cleaning, repairing,
or inspecting the cordless claw tiller + cultivator.
• Regularly check the following:
i) Blades are clear and can rotate freely –
Accumulation of debris around the blades could impair
performance or damage the motor. Inspect and clean the
area around the blades before every use.
ii) Safety devices are operating properly –
Do not tamper with or adjust safety devices.
iii) Bolts and screws are properly tightened –
Visually inspect the machine for any damage and ensure
that the cordless claw tiller + cultivator is in safe working
condition.
iv) Use only identical replacement parts –
Always replace damaged parts with original equipment
manufacturer’s (OEM) parts only. Replacement parts that
do not meet the original equipment specifications may
lead to improper performance and compromise safety.
Battery + Charger
Safety Instructions
We pay a great deal of attention to the design of every battery
pack to ensure that we supply you with batteries that are safe,
durable and have a high energy density. The battery cells have
a wide range of safety devices. Each individual cell is initially
formatted and its electrical characteristic curves are recorded.
This data is then used exclusively to be able to assemble the
best possible battery packs.
Despite all the safety precautions, caution must always be
exercised when handling batteries. The following points must
be obeyed at all times to ensure safe use. Safe use can only be
guaranteed if undamaged cells are used. Incorrect handling of
the battery pack can cause cell damage.
IMPORTANT! Analyses confirm that incorrect use and poor care
of high-performance batteries are the main factors responsible
for personal and/or product damage.
mWARNING! Use only approved replacement batteries;
other batteries may damage the power tool and cause it to
malfunction, which can lead to serious personal injury.
mWARNING! Do not use a battery pack or appliance that
is damaged or modified. Damaged or modified batteries may
exhibit unpredictable behavior resulting in fire, explosion or risk
of injury.
Do not modify or attempt to repair the appliance or the battery
pack except as indicated in the instructions for use and care.
Have your battery pack serviced by a qualified repair person
using only identical replacement parts. This will ensure that the
safety of the battery pack is maintained.
mCAUTION! To reduce the risk of injury, charge the
24V* IONMAX lithium-ion battery pack only in its designated
24V* IONMAX lithium-ion charger. Other types of chargers
present risk of fire, personal injury and damage. Do not wire a
battery pack to a power supply plug or car cigarette lighter. Such
misuse will permanently disable or damage the battery pack.
• Avoid dangerous environments – Do not charge the battery
pack in rain, snow or in damp or wet locations. Do not use
the battery pack or charger in the presence of explosive
atmospheres (gaseous fumes, dust or flammable materials)
because sparks may be generated when inserting or
removing the battery pack, which could lead to a fire.
• Charge in a well-ventilated area – Do not block the charger
vents. Keep them clear to allow for proper ventilation. Do not
allow smoking or open flames near a charging battery pack.
Vented gases may explode.
The safe temperature range for the battery is NOTE:
41°F (5°C) to 105°F (40.5°C). Do not charge the battery
outside in freezing weather; charge it at room temperature.
• Maintain charger cord – When unplugging the charger,
pull the plug, not the cord, from the receptacle to reduce the
risk of damage to the electrical plug and cord. Never carry the
charger by its cord or yank it by the cord to disconnect it from
the receptacle. Keep the cord away from heat,
oil and sharp edges. Make sure the cord will not be stepped
on, tripped over or subjected to damage or stress when the
charger is in use. Do not use the charger with a damaged
cord or plug. Replace a damaged charger immediately.
• Do not use an extension cord unless it is absolutely
necessary – Using the wrong, damaged or improperly wired
an extension cord must be used, plug the charger into a
properly wired 16 gauge or larger extension cord with the
female plug matching the male plug on the charger. Make
sure that the extension cord is in good electrical condition.
• Use only recommended attachments – Use of an
attachment not recommended or sold by the battery charger
or battery pack manufacturer may result in risk of fire,
electric shock or personal injury.
• Unplug charger when not in use – Make sure to remove
battery packs from unplugged chargers.
mWARNING!
To reduce the risk of electric shock,
always unplug the charger before performing any cleaning or
maintenance. Do not allow water to flow into the charger. Use a
Ground Fault Circuit Interrupter (GFCI) to reduce shock hazards.
• Do not burn or incinerate battery packs –
Battery packs may explode, causing personal injury or
damage. Toxic fumes and materials are created when battery
packs are burned.


Produktspezifikationen

Marke: Sun Joe
Kategorie: Nicht kategorisiert
Modell: 24V-CTLR-LTE

Brauchst du Hilfe?

Wenn Sie Hilfe mit Sun Joe 24V-CTLR-LTE benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten