Sussex RWBHS200RH Bedienungsanleitung

Lies die bedienungsanleitung für Sussex RWBHS200RH (1 Seiten) kostenlos online; sie gehört zur Kategorie Kran. Dieses Handbuch wurde von 44 Personen als hilfreich bewertet und erhielt im Schnitt 4.8 Sterne aus 7 Bewertungen. Hast du eine Frage zu Sussex RWBHS200RH oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Tapware is to be installed by a Licensed Plumber in accordance with AS/NZS 3500:2003

Recommended working water pressure 300-500 kpa. Maximum water temperature is 65 deg.c

Copyright © Sussex Taps.

Pipe Connections

1/2" BSP

HOT

IN

OUTLET

1/2" BSP

COLD

IN

1A

NOGGING

WALL

STUD

28-32

Wall Covering

25mm

"ROUGH-IN" View from above

90

OUTLET

IN-WALL BODY

MASTERFIT

THIS

SIDE

UP

AS/NZS 3718:2005

LIC. 20081

1

LOCKING

SLEEVE

HANDLE

DRESS

RING

5.5

litres per

minute

Licence No. 0124

In accordance with AS/NZS 6400

Sussex Taps Pty Ltd

WATER RATING

www.waterrating.gov.au

The more

stars the more

water efcient

Product code

Circa

Wall basin hostess system

Fitting off

Pipe connections

Rough in plumbing (MASTERFIT) mounting guide

-The Masterfit will be supplied with the Spindles pre-installed.

-Prepare a nogging and secure 28-32mm back from the front Using the screws (x4) of the stud (See Fig.1)

-The Masterfit (in-wall) will be marked “This side Up” to Ensure the Masterfit is indicate orientation.

-Using the screws (x4) provided, mount the Masterfit (in-wall) to the Nogging.

-Ensure the Masterfit is level and square to the Wall Studs.

-Seal the wall around the Locking Sleeve and immediately fit the Dress Ring.

-Fit the Handle Body, the Handle Body must be fully engaged onto the Spindle; note the Set Screw contact point.

(See Fig.1B)

-Secure the Handle body by tightening the Set screw using the 2mm Allen key provided. (Tighten well)

-After completing the installation, establish water supply, check function of Tapware and ensure no water leaks.

-The Masterfit is supplied with coloured thread Caps to protect and identify the Hot and Cold inlet connections.

-All lines must be free from any dirt and debris before connecting to the Masterfit. Flush all water feed lines.

-Connect Hot and Cold lines to the corresponding 1/2” BSP ports of the Masterfit. (See Fig.1A)

-Do not remove or disturb any factory fitted Pressure Plugs or Fixings.

-Once all water connections are made, use the “Spindle Handle Adapter” and check Hot/Cold water operation.

-Check all fittings and connections for leaks.

-Store the Dress Kit in a safe place until required for Fit off.

RWBHS150RH Wall basin hostess syst 150mm

RWBHS200RH Wall basin hostess syst 200mm

RWBHS250RH Wall basin hostess syst 250mm

RWBHS150RH-V Wall basin hostess syst 150mm - Vertex

RWBHS200RH-V Wall basin hostess syst 200mm - Vertex

RWBHS250RH-V Wall basin hostess syst 250mm - Vertex

sussextaps.com.au

Produktspezifikationen