TacTic DroneView TACZ1000 Bedienungsanleitung
Lies die bedienungsanleitung für TacTic DroneView TACZ1000 (20 Seiten) kostenlos online; sie gehört zur Kategorie Camcorder. Dieses Handbuch wurde von 37 Personen als hilfreich bewertet und erhielt im Schnitt 4.4 Sterne aus 19 Bewertungen. Hast du eine Frage zu TacTic DroneView TACZ1000 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/20
The Tactic Droneview Camera is powered by an included
1S 3.7V 350mAh lithium-polymer battery (LiPo).
IMPORTANT: It will be necessary to fully charge the
battery with the included USB charge cable before
use! Follow all safety precautions below before
proceeding. Failure to do so may cause the camera
to lose power prematurely, resulting in a loss of data.
●
NEVER LEAVE BATTERY UNATTENDED WHILE CHARGING.
●
Never allow battery temperature to exceed 140°F (60°C).
● Never place the battery on combustible materials while
charging.
● Never attempt to disassemble or modify the battery.
● Never attempt to charge or to use the battery if it’s
swollen, punctured, or deformed in any way.
● Never attempt to charge the battery with an
incompatible battery charger.
● Follow appropriate disposal instructions when the
battery has reached the end of its useful life.
CHARGE THE CAMERA BATTERY
1. Connect the included USB charge cable to a computer’s
USB Port or to an AC to USB adapter.
2. Connect the LiPo battery to the jack on the opposite
end of the charger.
3. The Battery Charge Meter LEDs will start ashing to
indicate that the charge cycle has started.
4. When the battery is charged, the Battery Charge Meter
LEDs will stop ashing and remain on.
5 The battery will recharge in about 50 minutes if the
camera is turned off and will operate the camera
for about the same time. The USB charge cable can
be used while the camera is operating to extend the
camera’s run time.
QUICK START
When the camera is turned on, it needs 30 seconds to
setup before it can be used.
LED will ash when camera is in use.
Must be steady for 30 seconds before
the camera is turned off.
Insert or remove the
memory card only when
the camera is off.
Tap to turn the
camera on or off.
Tap to take a picture. Hold
for 2 seconds to start video.
Tap to stop video.
Turn the camera
off when just one
LED has been on
for 10 minutes.
If the camera loses Wi-Fi connection and there is
another network that the device can connect to, iOS
users must go into the Wi-Fi settings and select the
Droneview network. Android devices will usually re-
connect automatically and the user should wait about
a minute before going to the Wi-Fi settings page.
If the battery dies while recording a video or the
camera is turned off before the le is saved to the
memory card, the current le may be lost or corrupted.
Always wait 30 seconds before turning the camera
off after recording a video or taking a picture.
Always use a class 10 card in the Droneview camera.
Always insert and remove the memory card when the
camera is turned off.
Produktspezifikationen
| Marke: | TacTic |
| Kategorie: | Camcorder |
| Modell: | DroneView TACZ1000 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit TacTic DroneView TACZ1000 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Camcorder TacTic
25 Juli 2024
Bedienungsanleitung Camcorder
- Mamiya
- Magellan
- Microtek
- DOD
- Mpman
- AgfaPhoto
- Akaso
- Mobius
- Leica
- CamOne
- Kaiser Baas
- Sakar
- Prixton
- GOCLEVER
- Sharp
Neueste Bedienungsanleitung für -Kategorien-
30 Juli 2025
30 Juli 2025
29 Juli 2025
29 Juli 2025
29 Juli 2025
29 Juli 2025
29 Juli 2025
29 Juli 2025
29 Juli 2025
29 Juli 2025