Tornado T-3000 Bedienungsanleitung
Lies die bedienungsanleitung für Tornado T-3000 (2 Seiten) kostenlos online; sie gehört zur Kategorie Spielzeug. Dieses Handbuch wurde von 19 Personen als hilfreich bewertet und erhielt im Schnitt 4.3 Sterne aus 10 Bewertungen. Hast du eine Frage zu Tornado T-3000 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/2
The Tornado Platinum Tour Edition and T-3000 tables are assembled with rods and
men installed at the factory for ease of setup. These helpful steps will clearly guide
you from “two boxes” to “fully functional in Foosball.”
The tables come packed in two boxes for ease of assembly. Each is a matched pair
consisting of two different size boxes that will have matching serial numbers. If re-
ceiving more than one table Do not mix and match the tops and bottoms, as they —
will not fit correctly. To properly move and assemble a table, have these handy
• At least one helper
• A Two-wheel dolly to move the boxes
• A Hammer
• A power screwdriver or drill with #2 Phillips bit
(or a Phillips screwdriver)
• A 3/4” open-end wrench to lock the leg levelers
• A ratchet with a 9/16” socket, or 9/16” wrench
• A level. The larger the better, up to about 24 inches
• Clean, dry cloths
• For a coin table: Coins to test the push chute mechanism
Open the smaller box first. It contains the base of the cabinet.
After you have taken off the lid stand the table up on its end and get the box out
of the way. To avoid scratching the table, this is best done on carpet or card-
board.
Watch for any loose items that may fall out of the base .
While the table is on its end knock out the blocks retaining the legs with a ham-
mer. Be careful they don’t fall on you.
Remove the nuts and washers and install the bottom legs first, then the top
ones. This is your best chance to make sure the nuts are snug.
If the leg levelers are not fully turned in, do so. You will loosen them later when
leveling the table.
Now stand the base up. Good idea to have a helper to catch it.
Place the base where you want the game to be installed.
Open the parts pack and install the coin mechanism with 4 screws and washers
and 2 allen bolts connect it to the ball trap.
You will remove a block that holds the ball trap in place. Test the mechanism a
few times to make sure the trap rotates properly and that the coin meter moves
1 number each time.
Produktspezifikationen
| Marke: | Tornado |
| Kategorie: | Spielzeug |
| Modell: | T-3000 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Tornado T-3000 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Spielzeug Tornado
25 September 2025
25 September 2025
28 August 2025
Bedienungsanleitung Spielzeug
- ARCHOS
- Nils Extreme
- Tot Tutors
- Razor
- Snow Joe
- Bellelli
- Dynacraft
- Velleman
- Disney
- Snap Circuits
- Berg
- Oregon Scientific
- Megableu
- Ugears
- WowWee
Neueste Bedienungsanleitung für -Kategorien-
20 Januar 2026
18 Januar 2026
17 Januar 2026
17 Januar 2026
14 Januar 2026
13 Januar 2026
13 Januar 2026
13 Januar 2026
9 Januar 2026
9 Januar 2026