WAC Lighting HR-LED87S Bedienungsanleitung

Lies die bedienungsanleitung für WAC Lighting HR-LED87S (2 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 8 Personen als hilfreich bewertet und erhielt im Schnitt 4.4 Sterne aus 4.5 Bewertungen. Hast du eine Frage zu WAC Lighting HR-LED87S oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

WAC Lighting

www.waclighting.com

Phone (800) 526.2588 • Fax (800) 526.2585

Headquarters/Eastern Distribution Center

44 Harbor Park Drive • Port Washington, NY 11050

Phone (516) 515.5000 • Fax (516) 515.5050

Western Distribution Center

1750 Archibald Ave • Ontario, CA 91761

Phone (800) 526.2588 • Fax (800) 526.2585

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 20154

INSTALLATION INSTRUCTION

24V LED Button Lights - round

HR-LED87

CAUTION :

TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK AND INJURIES TO PERSONS:

• Use only insulated staples or plastic ties to secure cords.

• Route and secure cords so they will not be pinched or damaged when cabinet is pushed to the wall.

• Not intended for recessed installation in ceilings.

• Use 24V WAC Class 2 transformer.

RECESS MOUNT

1. Cut a 2 1/8” diameter hole on the surface.

2. The decorative cover piece is not needed for

recessed mounting, and may be discarded.

3. Feed the fixture wires through the hole, and connect

to wires from the transformer with wire nuts provided.

4. Compress the springs on either side of the fixture

and insert into the opening.

SURFACE MOUNT

1. Wires may be run behind the fixture or along a surface.

Determine the most convenient location for wire passage.

The “D” shaped knock out hole in the cover piece allows wire

to exit and run along a surface.

To wire behind the fixture, drill a hole in the surface sufficient

to allow the socket wires through. Punch the knock out in the

cover piece and align with the hole.

2. Screw the cover piece to the surface with screws provided.

3. Feed the fixture wires through the hole, and connect to wires

from the transformer with wire nuts provided.

4. Compress the springs on either side of the fixture and

insert into the back cover.

CLASS 2 WIRING:

Cabinet fixtures require 24V Class 2 transformers. Class 2 transformers are by definition “Power limited” (5 amps maximum) and “Inherently

Protected” (fused). Primary wires to the transformer enclosure must follow normal NEC chapter 3 wiring techniques. Non enclosed secondary

wiring and splices are not restricted in concealed spaces.

Produktspezifikationen