Wimberley The Plamp II PP-211 Bedienungsanleitung

Lies die bedienungsanleitung für Wimberley The Plamp II PP-211 (2 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 17 Personen als hilfreich bewertet und erhielt im Schnitt 4.3 Sterne aus 9 Bewertungen. Hast du eine Frage zu Wimberley The Plamp II PP-211 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Wimberley, Inc. ©2018, All Rights ReservedRev.180325

Arched Recess

reliablygrip cylindrical

objectssuch as small

flashlights and branches.

Foam Jaw Inserts

Grip delicate objects without damage.

The Plamp Clip

Thumbscrew Turn the thumbscrew to open or close the jaws of the

clip. Compared to typical spring-activated clips, thumbscrew activated

clip jaws allow for more finesse when holding delicate objects, as well

as much higher maximum clamping force when desired.

Clip Body

The clip is custom designed to hold

anything from the most delicate plant stems

to heavy reflectors and diffusers. It is made of

nearly unbreakable ST Nylon

Jaw opening band

This elastomer band puts tension on the clamp’s moving

jaw so that it opens when you loosen the thumbscrew. It

is made of weather/UV resistant EPDM

Special notches in the clip’s jaws grab the steel rim on reflectors and

diffusers, providing a secure, slip-free attachment (applies to typical cloth

reflectors/diffusers with steel perimeter hoop). This new feature is a drastic

improvement over other clips currently on the market.

The firm grip allows you to make precise adjustments to the angle of a reflector.

You can even hold diffusers cantilevered straight out above your subject

Important Feature

Reflector/Diffuser Notches

Package Contents:

• The Plamp Clip (Qty 1)

Connecting the Plamp Clip to your Plamp

1. Remove the old clip end from the

Plamp by firmly grabbing the Loc-Line®

segment next to the end segment that is

attached to the clip. Bend it sharply until

the segments pop apart (do not worry,

you will not hurt the Plamp).

2. To attach the new clip, forcefully press it onto the segment

that was previously attached to the old clip. It should snap into

place with an audible “pop”. It takes a substantial amount of

pressure to make this happen. It helps to place your fists be-

tween your knees, holding the mating pieces as close to the

connecting joint as possible. Squeeze your knees together

forcefully as you force the joints together with your hands.If

you are still having difficulty you can heat up the female socket

to facilitate the process (details be-

low).

Heating the female socket:

Heat some water to boiling or near-

boiling temperature. Warm the female

end of the segment for 30-60 seconds in

the hot water. Connect the segments by

pushing them together. Use the knee-

squeezing technique mentioned above if

needed. The segments should pop into

place fairly easily.

Wimberley, Inc.Phone: 1-434-529-8385

1750 Broadway StToll Free:1-888-665-2746 (USA & Canada)

Charlottesville, VA

22902 USAwww.tripodhead.cominfo@tripodhead.com

5 Year Warranty –See www.tripodhead.com/warranty.cfm for complete details

Made in USA

PP-211

The Plamp II

Thumbscrew Clip

Produktspezifikationen