Wind River H3000 Bedienungsanleitung

Lies die bedienungsanleitung für Wind River H3000 (2 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 2 Personen als hilfreich bewertet und erhielt im Schnitt 4.8 Sterne aus 3 Bewertungen. Hast du eine Frage zu Wind River H3000 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Programming the remote

Note: Not all the receivers can match this transmitter. This transmitter should work in conjunction with

RC-Receiver.

Install a A23,12 Volt battery(included.)To prevent damage to transmitter remove the battery if not used for long

periods of time.

Step 1: Turn the power off to your ceiling fan.

Step 2: Please use a small size tool to change the frequency settings on the control system.

The system is equipped with a learning frequency function which has 16 code combinations to prevent

potential interference from other remote units.The frequency on your receiver and transmitter units have

been preset at the factory.

Dimmable Function: Set code labeled “1” to “On” for dimming light function. If using CFL bulbs or

Non-Dimmable bulb, set code to "ON" position for non-dimming function.

Step 3: Return power to the unit.

Note: After the AC power is on, do not press any other button on the transmitter before pressing the " "

button; doing so will cause the procedure to fail.

Setp 4: Within 60 seconds of turning the Fan's AC power ON. Press the transmitter's " " button and

hold the " " button for 5 seconds.

Setp 5: Once the receiver has detected the set frequency, the down light of your fan will blink twice and the

fan will be gin to rotate for a short period and then shut off.

Setp 6: The receiver has now learned the frequency which has been selected on the transmitter. After

completing the steps above, you should be able to operate the ceiling fan and light. If the fan is not

responding to the transmitter, please turn the power off to the receiver, and repeat the process.

Read and save these instructions

FIG. 2

MODEL:H3000

FIG. 1

1

ON

1234

ON[

*

]

1234

ON[

*

]

Dimmable function set code

1

ON

OPERATING THE TRANSMITTER

a. “ ” , “ ” and “ ” buttons:

These three buttons are used to select the fan speed.

Press and release the button of the desired speed setting:

= Lowest speed = Medium speed = Highest speed

b. “ ” button: This button will turn the light on or off and will also control the brightness setting. Press and

release the button and the light will turn on or cycle continuously between bright and dim settings as long as the

button is held down. The light key has auto resume, it will stay at the same brightness as the last time it was

turned off.

c. “ ” button: This button will turn the fan off.

Produktspezifikationen