APC SU028RM3U Bedienungsanleitung

Lies die bedienungsanleitung für APC SU028RM3U (1 Seiten) kostenlos online; sie gehört zur Kategorie Unterbrechungsfreies Stromversorgungssystem. Dieses Handbuch wurde von 27 Personen als hilfreich bewertet und erhielt im Schnitt 4.2 Sterne aus 8 Bewertungen. Hast du eine Frage zu APC SU028RM3U oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

990-7028D, 9/2003

ARP CCESSORY ECEPTACLE LATE

Entire contents copyright © 2003 by American Power Conversion Corporation. All rights reserved. Reproduction in whole

or in part without permission is prohibited. APC, Smart-UPS, and PowerChute are registered trademarks of American Power Conversion

Corporation. All other trademarks are the property of their respective owners.

Safety

Qualified service personnel must perform installation.

Ensure that the UPS is off and disconnected from utility power. The exposed electrical terminals will be energized if

the UPS is on or connected to utility power during the following procedure.

Installation

Note: Illustrations in this document may differ slightly from the actual hardware.

1. Unpack and inspect the accessory receptacle plate. Notify the carrier and dealer if there is damage. Recycle the

packaging or dispose of it properly.

2. Prepare the UPS for installation. Shut down and unplug all connected loads.

3. Turn off the UPS. Disconnect the UPS from utility power.

4. Unscrew the receptacle plate at the rear of the UPS. See figures below.

5. Pull the plate out gently so that the in-line connectors are accessible.

6. Press the locking tabs on the sides of the connectors and pull the connectors apart. Do not pull on the wires. Set aside the

old plate.

7. Align the new receptacle plate behind the UPS.

8. Match the corresponding connectors and snap together. See figures below.

9. Replace the receptacle plate and screws. See figures below.

10. Connect the UPS to utility power. Connect the loads. Turn on the UPS.

Figure 1:

Tower UPS and plate

configuration

Figure 2:

5U rack-mount UPS and plate

configuration

Figure 3:

Alternate 2U/3U rack-mount UPS and plate

configuration

Produktspezifikationen