Atlas Sound GSS-G Bedienungsanleitung

Lies die bedienungsanleitung für Atlas Sound GSS-G (2 Seiten) kostenlos online; sie gehört zur Kategorie Lautsprecher. Dieses Handbuch wurde von 96 Personen als hilfreich bewertet und erhielt im Schnitt 4.5 Sterne aus 9 Bewertungen. Hast du eine Frage zu Atlas Sound GSS-G oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

1/2

AtlasSound.com

TELEPHONE: (800) 876-3333

FAX (800) 765-3435

©2010 Atlas Sound L.P. All rights reserved. Atlas Sound is a trademark of Atlas Sound L.P. All other trademarks are the property of their respective owners. All specs are subject to change without notice. ATS002960 RevE 7/12

GSS-G & GST-G

Garden Speaker

1601 JACK MCKAY BLVD.

ENNIS, TEXAS 75119 U.S.A.

Key Features

• DownwardFiringSpeakerWillNotCollectDustorCondensation

• RuggedConstructionCanSupportUpTo250lbs

• EasyBayonetAttachmentofHeadUnitToBase,EnablesInstallation

ofBaseDuringExcavationandInstallationofHeadUnitAfter

LandscapingHasBeenCompleted

•SwitchSelectable70VInputorDirect8 Input(TransformerBypass)Ω

• EasyConduitInstallationinTallandShortBaseWithDedicated

MountingPads

• SpeakerProtectedByTripleLayerGrille

• ShortBase(GSS-G)hasDrillPointsfor4"Square,2-GangEOBox,or

1-GangBoxMountingtoaDeckorSlab

Instructions

To Install GST-B Tall Base Unit:

1. Makesureyouhaveapathtoburywireconnectedtospeaker.

2. Digahole8"deepx30"diameter.

3. Runwiretohole.

4. Attachconduitorglandnuttoflatsonbase.

5. Bringinwireandleavesufficientcableforadequateserviceloop

(minimum18")toreachheadunit.

6. Fillbasewithcleandirtorsandtowithin2"-3"oftopforoptimum

bassperformance.

7. Coverwithprovidedtemporarylidandattachwithprovided

1"screwsifheadunitisnottobeattachedimmediately.

8. Backfilldirttobase.Topofbaseshouldbe2"–3"aboveground.

To Install GSS-G Short Base Unit:

If Using an EO Box:

1. Install1-Gang,2-Gang,or4"x4"boxflushtomountingsurface.

2. Cutoutscribedlineonbottomofbasefor1-or2-gangbox.

3. Drillappropriateholesinbase(outer4holesfor4"x4",inner4for

2-gang,or1setof2innerfor1-gang).

4. Installwiringinbox.

5. Setbaseonboxandattachwithscrews.

If Using Conduit:

1. Mountbasetosurfacewithappropriatescrewsthroughthebase

bottom.

2. Attachconduitandbringinwire.Provideforsurfaceloop

(minimum18").

3. Coverwithprovidedtemporarylidandattachwithprovided1"screws

ifheadunitisnottobeattachedimmediately.

GST-G

Tall Base

GSS-G

Short Base

Produktspezifikationen