Atlas Sound GST-G Bedienungsanleitung

Lies die bedienungsanleitung für Atlas Sound GST-G (2 Seiten) kostenlos online; sie gehört zur Kategorie Lautsprecher. Dieses Handbuch wurde von 46 Personen als hilfreich bewertet und erhielt im Schnitt 4.5 Sterne aus 23.5 Bewertungen. Hast du eine Frage zu Atlas Sound GST-G oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

1/2

AtlasSound.com

TELEPHONE: (800) 876-3333

FAX (800) 765-3435

©2010 Atlas Sound L.P. All rights reserved. Atlas Sound is a trademark of Atlas Sound L.P. All other trademarks are the property of their respective owners. All specs are subject to change without notice. ATS002960 RevE 7/12

GSS-G & GST-G

Garden Speaker

1601 JACK MCKAY BLVD.

ENNIS, TEXAS 75119 U.S.A.

Key Features

• DownwardFiringSpeakerWillNotCollectDustorCondensation

• RuggedConstructionCanSupportUpTo250lbs

• EasyBayonetAttachmentofHeadUnitToBase,EnablesInstallation

ofBaseDuringExcavationandInstallationofHeadUnitAfter

LandscapingHasBeenCompleted

•SwitchSelectable70VInputorDirect8 Input(TransformerBypass)Ω

• EasyConduitInstallationinTallandShortBaseWithDedicated

MountingPads

• SpeakerProtectedByTripleLayerGrille

• ShortBase(GSS-G)hasDrillPointsfor4"Square,2-GangEOBox,or

1-GangBoxMountingtoaDeckorSlab

Instructions

To Install GST-B Tall Base Unit:

1. Makesureyouhaveapathtoburywireconnectedtospeaker.

2. Digahole8"deepx30"diameter.

3. Runwiretohole.

4. Attachconduitorglandnuttoflatsonbase.

5. Bringinwireandleavesufficientcableforadequateserviceloop

(minimum18")toreachheadunit.

6. Fillbasewithcleandirtorsandtowithin2"-3"oftopforoptimum

bassperformance.

7. Coverwithprovidedtemporarylidandattachwithprovided

1"screwsifheadunitisnottobeattachedimmediately.

8. Backfilldirttobase.Topofbaseshouldbe2"–3"aboveground.

To Install GSS-G Short Base Unit:

If Using an EO Box:

1. Install1-Gang,2-Gang,or4"x4"boxflushtomountingsurface.

2. Cutoutscribedlineonbottomofbasefor1-or2-gangbox.

3. Drillappropriateholesinbase(outer4holesfor4"x4",inner4for

2-gang,or1setof2innerfor1-gang).

4. Installwiringinbox.

5. Setbaseonboxandattachwithscrews.

If Using Conduit:

1. Mountbasetosurfacewithappropriatescrewsthroughthebase

bottom.

2. Attachconduitandbringinwire.Provideforsurfaceloop

(minimum18").

3. Coverwithprovidedtemporarylidandattachwithprovided1"screws

ifheadunitisnottobeattachedimmediately.

GST-G

Tall Base

GSS-G

Short Base

Produktspezifikationen