Axxess ASWC-TOY-LEX Bedienungsanleitung

Axxess Nicht kategorisiert ASWC-TOY-LEX

Lies die bedienungsanleitung für Axxess ASWC-TOY-LEX (8 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 13 Personen als hilfreich bewertet und erhielt im Schnitt 3.7 Sterne aus 7 Bewertungen. Hast du eine Frage zu Axxess ASWC-TOY-LEX oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Download PDF

Seite 1/8

INSTALLATION INSTRUCTIONS FOR PART ASWC-TOY-LEX

REV. 1/2/2014 INSTASWC-TOY-LEX

CAUTION: Metra recommends disconnecting the

negative battery terminal before beginning any

installation. All accessories, switches, and especially

air bag indicator lights must be plugged in before

reconnecting the battery or cycling the ignition.

NOTE: Refer to the instructions included with the

aftermarket radio.

• OneInterfacedoesitall-Noadditionalinterfacesneeded

• Automaticallyprogramsthebuttonsonthesteeringwheel

• Autodetectswhatradioit’sconnectedto

• Workswithallmajorradiobrands

• USBupdatable

• Allconnectionsaremadebehindtheradio

• Non-volatilememoryretainssettingsevenifbatteryisdisconnectedorinterfaceis

removedfromthevehicle

KIT FEATURES

•Cuttingtool•Crimpingtool•Tape•Connectors

(example:butt-connectors,bellcaps,etc.)

TOOLS REQUIRED

Axxess Steering Wheel Control interface

for select Toyota and Lexus vehicles

APPLICATIONS

See inside front cover

•ASWC-TOY-LEXinterface•12-pinharnesswith

male3.5mmto12and6-pinharness•Female

3.5mmconnectorwithBrownandBrown/White

wires•12kohmresistor

INTERFACE COMPONENTS

ASWC-TOY-LEX

Applications

TOYOTA

Avalon 2003-2004

Prius 2001-2003

Sienna 1999-2003

LEXUS

GS300 1998-2005

GS430 2001-2005

LX470 2001-2002

SC430 2002-2009

Into vehicle

1) Connectthe wireoftheASWC-TOY-LEXtoground. mayusethesameBlack You

groundingpointastheaftermarketradio.

2) Connectthe wireoftheASWC-TOY-LEXtoa12voltaccessorywire,onethatturnsRed

onandoffwiththeignitionkey.

3) Dependingonthevehicleyouareinconnecteitherthe6-pinor12-pinconnectortothe

matingvehicleharness.

To radio

1) theradiosbelow,plugtheincludedfemale3.5mmconnectorwiththe and For Brown

Brown/Whitewiresintothemale3.5mmconnectoroftheASWC-TOY-LEXharness.

• ConnecttheEclipsesteeringwheelcontrolwires(normallyFor Eclipse radios:

Brown Brown/Black Brown Brown/White and )tothe and wiresofthe

ASWC-TOY-LEX.BrownoftheASWC-TOY-LEXgoestothe oftheBrown/Black

Eclipseand oftheASWC-TOY-LEXgoestothe oftheEclipse.Brown/White Brown

• ConnecttheSWCKey1wire tothe wireoftheFor Metra OE: (Grey) Brown

ASWC-TOY-LEX.Isolateandtapethe wire,itwillnotbeused.Brown/White

• For Kenwood or select JVC’s Blue/Yellowwitha steeringwheelcontrolwire:

ConnecttheKenwood/JVCsteeringwheelcontrolwiretothe wireoftheBrown

ASWC-TOY-LEX.Isolateandtapethe wire,itwillnotbeused.Brown/White

Installation

Table of Contents

Installation

– Intovehicle............................................................................................2

– Toradio.............................................................................................. 2-3

Programming...........................................................................................3

Troubleshooting.......................................................................................3

Manually changing radio.........................................................................4

– Radiolegend..........................................................................................4

Remapping the SWC buttons..................................................................5

– Buttonassignmentlegend......................................................................5

– ResettingtheSWCbuttonsbacktodefault.............................................5

ASWC-TOY-LEX

Installation

Note: Some of the newer Kenwood radios will auto detect as a JVC. If this is

the case, use the included 12k ohm resistor in line between the Blue/Yellow

and Brown wire of the female 3.5mm jack during programming only (remove

resistor once programmed). Or you can manually set the radio type which is in

the Manually Changing Radio Type section.

2) For Parrot Asteroid Smart or Tablet:ConnecttheASWC-TOY-LEXmale3.5mm

jackintotheAX-SWC-PARROT(soldseparately)female3.5mmjackandplug

the4-pinendintothecorrespondingSWCplugontheradio.

 Note: AX-SWC-PARROT (sold separately) and radio required must be

updated to rev 2.1.4 or higher.

3) Pluginthemale3.5mmconnectoroftheASWC-TOY-LEXFor all other radios:

intothebackoftheaftermarketradio,designatedforanexternalsteeringwheel

controlinterface.Pleaserefertotheaftermarketradiosmanualifyouarein

doubtwherethe3.5mmconnectoroftheASWC-TOY-LEXgoes.

4) Onceallconnectionshavebeenmade,plugintheaftermarketradioifnot

donealready.

2) Oncesolid,theASWC-TOY-LEXshouldbeworking.

Note: The ASWC-TOY-LEX will give you two sets of LED feedback reports. The

first set of flashing green LED lights is for knowing the vehicle type and the

second set of red flashing LED lights is for knowing the radio type. Knowing the

vehicle type is irrelevant as this interface is pre-programmed for vehicles in the

application list only. But knowing the radio type is important for troubleshooting

if the ASWC-TOY-LEX does not work. Please see the below Radio Legend for

LED feedback information for radio type.

Programming

Troubleshooting

1) Confirmthatthe3.5mmconnectorisconnectedtoyourradiosecurely inand

thecorrectlocation.

2) Ifusingthefemale3.5mmconnectorinEclipse,Kenwood,selectJVC,orMetra

OEradios,verifythattheradio’ssteeringwheelcontrolwireisconnectedtothe

correctwiretotheASWC-TOY-LEX.

Note: Not every radio will have all the possible SWC commands on the steering

wheel. Please refer to the radio owner’s manual or contact the radio vendor for

specific commands that the radio will recognize.

TheASWC-TOY-LEXwillautoprogramitselfthroughAutoDetectMode.

1) TurntheignitiononandwaituntiltheLEDontheASWC-TOY-LEXgoessolid

(abouttwentyseconds).

Note:Do not press any buttons on the steering wheel or radio during this time.

Programming

Produktspezifikationen

Marke:	Axxess
Kategorie:	Nicht kategorisiert
Modell:	ASWC-TOY-LEX

Brauchst du Hilfe?

Wenn Sie Hilfe mit Axxess ASWC-TOY-LEX benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten

Ihren Namen*

Deine E-Mail*

Schreiben Sie hier Ihre Frage

Bedienungsanleitung Nicht kategorisiert Axxess

Axxess AX-MLOC-HD1 Bedienungsanleitung

12 September 2024

Axxess AFSI-01 Bedienungsanleitung

30 August 2024

Axxess AX-TOYCAM3 Bedienungsanleitung

30 August 2024

Axxess AX-MITSUCAM Bedienungsanleitung

30 August 2024

Axxess AX-TOYRSAV Bedienungsanleitung

30 August 2024

Axxess HDCC-02 Bedienungsanleitung

30 August 2024

Axxess AX-TOYCAM2 Bedienungsanleitung

30 August 2024

Axxess AX-ADBOX1 Bedienungsanleitung

30 August 2024

Axxess CHRYSAV Bedienungsanleitung

30 August 2024

Axxess 70-8215AMP Bedienungsanleitung

30 August 2024

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-

Hamlet XHUB-04U3P Bedienungsanleitung

15 Juni 2025

FLIR Scout Pro Bedienungsanleitung

15 Juni 2025

BEKO BBIM13000X Bedienungsanleitung

15 Juni 2025

Hamlet XHUB7020AL Bedienungsanleitung

15 Juni 2025

Netgear GS524v3 Bedienungsanleitung

15 Juni 2025

Maestro MR-320C Bedienungsanleitung

15 Juni 2025

Keter Store It Out Pro 1200L Bedienungsanleitung

15 Juni 2025

Hamlet HURMAG3 Bedienungsanleitung

15 Juni 2025

Maestro MR-309C Bedienungsanleitung

15 Juni 2025

Hamlet XPW45000H Bedienungsanleitung

15 Juni 2025