Behringer 297 Dual Portamento/CV Utilities Bedienungsanleitung

Lies die bedienungsanleitung für Behringer 297 Dual Portamento/CV Utilities (2 Seiten) kostenlos online; sie gehört zur Kategorie Hamer. Dieses Handbuch wurde von 37 Personen als hilfreich bewertet und erhielt im Schnitt 4.6 Sterne aus 7 Bewertungen. Hast du eine Frage zu Behringer 297 Dual Portamento/CV Utilities oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

V 1.0

Quick Start Guide

SYSTEM 100

297 DUAL PORTAMENTO/

CV UTILITIES

Legendary Analog Portamento

Controller and CV Utilities for Eurorack

Controls

(1) MIXER SIG IN – Connect incoming signals via 3.5 mm

TS cables. Inputs 3 and 4 feed +10/-10 V respectively to

the mixer inputs if no jack is inserted, which can be used

to oset the overall mixer output control voltage.

(2) PORTA SIG OUT – Send the portamento signal to another

module via 3.5 mm TS cable.

(3) PORTA SIG IN – Connect a signal to the portamento

section via 3.5 mm TS cable.

(4) SIG LEVEL – Adjust the level of the signals connected to

the mixer inputs.

(5) INV OUT – Send the mix of inputs 1-4 as an

inverted signal.

(6) NON INV OUT – Send the mix of inputs 1-4 as a

non-inverted signal.

(7) TIME – Adjust the portamento time.

(8) CV IN – Connect a voltage to control the portamento time

from another module.

(9) +10/-10 V LEVEL – Adjust the level of the +10 V and

-10 V outputs.

(10) +10/-10 V OUT – Send the +10 V and -10 V signals via

3.5 mm TS cable.

Power Connection

The module comes with the required power cable for connecting

to a standard Eurorack power supply system. Follow these

steps to connect power to the module. It is easier to make

these connections before the module has been mounted into

a rack case.

1. Turn the power supply or rack case power o and

disconnect the power cable.

2. Insert the 16-pin connector on the power cable into the

socket on the power supply or rack case. The connector has

a tab that will align with the gap in the socket, so it cannot

be inserted incorrectly. If the power supply does not have

a keyed socket, be sure to orient pin 1 (-12 V) with the red

stripe on the cable.

3. Insert the 10-pin connector into the socket on the back of

the module. The connector has a tab that will align with the

socket for correct orientation.

4. After both ends of the power cable have been securely

attached, you may mount the module in a case and turn on

the power supply.

(1)

(4)

(5)

(6)

(3)(2)

(7)

(8)

(10)

(9)

Produktspezifikationen