Bogen UTI1 Bedienungsanleitung
Bogen
Nicht kategorisiert
UTI1
Lies die bedienungsanleitung für Bogen UTI1 (21 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 6 Personen als hilfreich bewertet und erhielt im Schnitt 4.6 Sterne aus 3.5 Bewertungen. Hast du eine Frage zu Bogen UTI1 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/21
Universal Telephone Interface
UTI1 Model
Addendum to the Installation and Use Manual
The following corrections to the UTI manual, part number 54-2095-0 A, are highlighted in bold and underlined.1 1
Trunk Disconnect (page 7)
The trunk disconnect feature is by default and can be . (Refer to disabled enabled System Programming.)
Override Input (page 10)
Maximum contact closure resistance is 000 ohms. Open collector type outputs for controlling a page may also be used.1
The Override feature includes a quad beep pre-announce tone that can be enabled or disab
led. (The default is enabled.)
Override Tone (page 13)
This tone is produced when override is activated. It produces a quad beep pre-announce tone that can be enabled or
disabled
. (The default is enab
led
). See System Programming to disab
le
the tone.
Feature Codes & Defaults
Feature
Feature
Code
Data Default
Override Tone
Disable
Enable
08
09 09
Trunk Disconnect
Disable
Enable
14
15
14
Block Diagram
NOTE: SYS GND has been added
to the line drawing on page 10
next to Dry Audio Input.
50 Spring Street, Ramsey, NJ 07446, U.S.A.
Tel. 20 -934-8500, Fax: 20 -934-9832, www.bogen.com1 1
© 2004 Bogen Communications, Inc.
All rights reserved.
Specifications subject to change without notice.
54-6707-0 A 04081
NOTE: SYS GND has been
added to the block diagram
next to Dry Audio Input.
Universal Telephone Interface
UTI1 Model
Installation and Use Manual
© 2004 Bogen Communications, Inc.
All rights reserved.
Specifications subject to change without notice.
54-2095-0 A 04061
© 2004 Bogen Communications, Inc.
All Rights Reserved. Printed in Taiwan.
Notice
Every effort was made to ensure that the information in this manual
was complete and accurate at the time of printing. However,
information is subject to change.
FCC Statement (Part 5) - Radio Frequency Interference1
The Universal Telephone Interface (UTI ) generates and uses radio1
frequency energy and if not installed and used in strict accordance
with the manufacturer's instructions, may cause interference to radio
and television reception. Testing is being conducted for compliance
with the limits for a Class B device in accordance with the
specifications in Part 5 of the FCC Rules and Canadian D.O.C.1
regulations.This testing is designed to provide reasonable protection
against such interference. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause interference to radio or television reception, which can be
determined by turning the UTI unit off and on, the user is1
encouraged to try to correct the interference by one or more of the
following measures:
- Reorient the radio or TV receiving antenna.
- Relocate the UTI unit with respect to the radio or TV receiver or1
vice versa.
- Plug the UTI unit into a different outlet so that it and the radio or1
TV receiver are on different branch circuits.
If necessary, the user should consult the dealer or an experienced
radio/television technician for additional suggestions.The user may find
the following booklet, "How To Identify and Resolve Radio-TV
Interference Problems," helpful. This booklet was prepared by the
Federal Communications Commission (FCC) and is available from the
U.S. Government Printing Office,Washington, DC 20402. Stock order
No. 004-000-00345-4.
Federal Communications Commission (FCC) Statement
(Part 68)
This equipment is component registered with the Federal
Communications Commission (FCC) in accordance with Part 68 of its
rules. In compliance with the rules, be advised of the following:
Registered equipment may not be used with Coin Telephone Lines.
Equipment may be used with Party Lines in areas where state tariffs
permit such connections and when equipment is adaptable for such
service.
This equipment is registered as follows:
Registration Number - CD2PA14BUT11
Ringer Equivalence - 1.4B
If trouble is experienced, the equipment should be disconnected from
the interface to determine if this equipment, or the telephone line, is
the trouble source. If the equipment is determined to be
malfunctioning, it should not be reconnected until repairs are effected.
Repairs to this equipment, other than routine repairs, can be made
only by the manufacturer or its authorized agents.
If the equipment causes harm to the telephone network, the local
telephone company may temporarily discontinue your service and, if
possible, notify you in advance. If advance notice is not practical, you
will be notified as soon as possible.You will be given the opportunity
to correct the problem and informed of your right to file a complaint
with the FCC.
The local telephone company may make changes in its facilities,
operations, or procedures that could affect the proper functioning of
your equipment.If they do, you will be given adequate notice in writing
to allow you an opportunity to maintain uninterrupted telephone
service.
Important Safety Information
Always follow these basic safety precautions when installing and using
the system:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. DO NOT block or cover the ventilation slots and openings. They
prevent the product from overheating. DO NOT place the product
in a separate enclosure or cabinet, unless proper ventilation is
provided.
4. Never spill liquid on the product or drop objects into the
ventilation slots and openings. Doing so may result in serious
damage to the components.
5. Repair or service must be performed by a factory authorized
repair facility.
6. The product is provided with a UL-CSA approved, 3-wire ground
type plug. This is a safety feature. DO NOT defeat the safety
purpose of the grounding type plug. DO NOT staple or otherwise
attach the AC power supply cord to building surfaces.
7. DO NOT use the product near water or in a wet or damp place
(such as a wet basement).
8. DO NOT use extension cords. The product must be installed
within 6 feet of a grounded outlet receptacle.
9. DO NOT install telephone wiring during a lightning storm.
10.DO NOT install telephone jacks in a wet location unless the jack
is specifically designed for wet locations.
11. Never touch uninsulated wires or terminals, unless the line has
been disconnected at the paging or controller interface.
12.Use caution when installing or modifying paging or control lines.
Produktspezifikationen
| Marke: | Bogen |
| Kategorie: | Nicht kategorisiert |
| Modell: | UTI1 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Bogen UTI1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Bogen
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
Bedienungsanleitung Nicht kategorisiert
- IK Multimedia
- Yellow Garden Line
- Novo Nordisk
- Daitsu
- Vertex
- Mutec
- Comelit
- GPX
- Baccarat
- Royal Sovereign
- Dr. Browns
- View Quest
- Traxxas
- Insteon
- MIOPS
Neueste Bedienungsanleitung für -Kategorien-
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025