Buchla & TipTop Audio Model 242t Bedienungsanleitung

Lies die bedienungsanleitung für Buchla & TipTop Audio Model 242t (1 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 8 Personen als hilfreich bewertet und erhielt im Schnitt 3.7 Sterne aus 4.5 Bewertungen. Hast du eine Frage zu Buchla & TipTop Audio Model 242t oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

PROGRAMMABLE PULSER - MODEL 242t

Pulses4 x 12 matrix can be programmed using the .

The “n”row selects the number of consecutive stages for rows A,

B and C.Rows A, B and C can independently programmed using

the two encoder knobs.

Eurorack 200 series

on/off

ssilstarttopngle puse

PROGRAMMABLE PULSER MODEL 242

.002OFF

10

PERIOD

INPRIXUTSTERMATALALL OUT

A

B

C

stop

start

period

123456789101112

C

B

A

n

CLK

IN

RST

IN

The , lower left knobscrolls through the vertical rowsthe lower

right knob horizontal rowson/o buttonscrolls through the . The

activates or clears the chosen pulse point and a long press clears

the matrix.

Above the matrix are manual , and buttons. stopsingle pulsestart

The “period” section controls the rate/speed of the internal clock

which drives the pulse matrix.

Incoming CVto the left hand attenuverter knob can increase or

decrease the rate selected by the right hand oset knob.

The oset rate goes from audio rate speed (.002) to 10 seconds (or

much longer) per stage.

The 242t can be externally clocked using the red jack. External pulses can also reset the end stage using the red “clk in” “rst in” jack.

“ALL OUT” sends out a continuous pulse train no matter what is programmed in the matrix. It is a direct output of the pulser.

“MATRIX” sends out individual pulse patterns as programmed in the matrix.

“ALTER” these two jacks send out alternating pulses—great for ping ponging.

The gray jack sends out a continuous ramp wave generated by the pulser,

great to send to open a 292t.

“INPUTS” These top two jacks can receive an external pulse to

either or the internal clock. startstop

Notes:

When the external clock (Clock In) is active, the “ramp” and "all out“

outputs remain controlled by the internal clock, as defined in the Period

section.

At the back of the module, a jumper sets the pulse length: "Short" uses the

pulser’s brief internal pulse width or the CLK input pulse width, while

"Long" fixes it to 1 millisecond. The factory default is "Long," recommended

for compatibility with most Eurorack modules.

Size: 16HP - Depth:45mm - Power: +12V 130mA / -12V 19mA

Produktspezifikationen