CRUX SWRFD-60L Bedienungsanleitung

Lies die bedienungsanleitung für CRUX SWRFD-60L (3 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 20 Personen als hilfreich bewertet und erhielt im Schnitt 4.9 Sterne aus 10.5 Bewertungen. Hast du eine Frage zu CRUX SWRFD-60L oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311

phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.020620

SWRFD-60L

Radio Replacement with SWC + Aux Input Retention

for FORD, LINCOLN & MERCURY Vehicles

1 of 3

RADIO REPLACEMENT

SWC RETENTION

+

R

INTERFACING SOLUTIONS

- Retains factory features in select FORD, LINCOLN, and MERCURY vehicles while functioning with an

aftermarket radio.

- Pre-programmed to retain factory Steering Wheel Controls.

- iPhone Voice Recognition (VR) feature from SWC on select Kenwood, Pioneer, Alpine and JVC radios.

- Retains factory Aux-Input and Subwoofer (if equipped).

- EIA color coded wiring for easy installation.

PRODUCT FEATURES:

PARTS INCLUDED:

INSTALLATION DIAGRAM:

SWRFD-60L MODULESWRFD-60L HARNESSAntenna AdapterSWC CABLE

AFTERMARKET

RADIO

+12V Constant Yellow

+12V ACC Red

12V Ground Black

Illumination Orange

Vehicle Speed Sense Red/White

(or Brown)

Subwoofer Amp Turn-on Blue/White

Antenna Turn-on Blue

Right Front (+) Gray

Right Front (-) Gray/Black

Left Front (+) White

Left Front (-) White/Black

Right Rear (+) Violet

Right Rear (-) Violet/Black

Left Rear (+) Green

Left Rear (-) Green/Black

Subwoofer

Factory Aux Input

24-Pin

Plug*

16-Pin

Plug*

8-Pin

Plug*

TO FACTORY

HARNESS

12-Pin

Connector

SWC TYPE

(Connect PINK to PINK wire)

Subwoofer

Converter

Module

*Inspect that the male pins are

properly lined up before plugging

into the factory harness.

SWRFD-60L

MODULE

ON RADIOVEHICLE

1 2 3 4 5 6 7 8

AFTERMARKET

RADIO SELECTOR

(See Chart)

FORD

SWC SETTING

(OFF OFF OFF OFF)

ON RADIOVEHICLE

1 2 3 4 5 6 7 8

Cap or insulate if

not being used

Kenwood/JVC (BLUE / YELLOW)Insulate with tape

if not being used

3.5MM SWC CABLE

Plug in the 3.5MM SWC cable to the 4-pin port

on the module. See “DIP SWITCH SETTINGS” section.

Blue/Yellow

(Not Used)

Produktspezifikationen