Draper 35807 Bedienungsanleitung
Seiten 2 Messung
Lies die Bedienungsanleitung für Draper 35807 kostenlos online oder lade das PDF herunter. 37 Personen fanden diese Anleitung hilfreich. Frage zu diesem Modell? Stelle eine Frage
EN
Version 2
June 2022
ETHYLENE GLYCOL
ANTIFREEZE
TESTER
(DISC TYPE)
35807 – AFT-4B INSTRUCTIONS FOR USE
Read this manual in full before attempting to use the
product and retain it for later use.
1. Scope
This product can be used to determine the level of
protection provided by ethylene glycol vehicle coolant
solutions. Protection is dependent on the ratio of
water and antifreeze chemicals present in the solution.
Measuring range: -37 to -7°C
2. Health and Safety Instructions
Important: Refer to the vehicle manufacturer’s
manual or the appropriate Haynes workshop manual
before use.EVERY
WARNING! Antifreeze solution is toxic; ALWAYS
read the label. If it comes into contact with your
eyes or skin, immediately ush with plenty of water.
If it is swallowed, drink plenty of water. In all cases,
and seek medical attention immediately.
• wear suitable protective gloves and ALWAYS
goggles when working with antifreeze solution.
•Clear any spillage immediately and with care.
•Wash the tester thoroughly after every use.
•Keep out of reach of children.
Important: ALWAYS dispose of antifreeze and coolant
solutions in accordance with local regulations.
3. Operation
Important: Read the Health and Safety information
before attempting to use this product. allow ALWAYS
the radiator to cool before removing the cap.
To avoid separation of the coolant solution, test the
solution while hot, after bringing the vehicle up to
temperature and then allowing the radiator to cool.
1. Run the vehicle engine to normal temperature if
necessary to mix fresh coolant.
2. Carefully remove the radiator cap using a cloth
and gloves.
WARNING! ALWAYS allow the radiator to
cool before opening it. The cooling system may
still be pressurised when opened and emit hot
steam, which can cause burns.
3. Insert the tester tube into the radiator reservoir
and squeeze the rubber bulb to draw uid into the
tester so that it is almost full.
Important: If the coolant solution is dirty or rusty,
drain, ush and rell the radiator, then clean the
tester and redraw the solution to the uid line.
4. Remove the tube from the reservoir and squeeze the
bulb lightly to expel any air bubbles from the uid.
5. Allow the discs to settle and observe the number of
discs that are oating (see below).
6. Flush the tester with hot soapy water and rinse clean
with warm water after use.
Produktspezifikationen
| Marke: | Draper |
| Kategorie: | Messung |
| Modell: | 35807 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Draper 35807 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Messung Draper
Draper Expert 80872 Bedienungsanleitung Draper 23707 Bedienungsanleitung Draper 90478 Bedienungsanleitung Draper 41026 Bedienungsanleitung Draper 24706 Bedienungsanleitung Draper 10204 Bedienungsanleitung Draper 23820 Bedienungsanleitung Draper 12442 Bedienungsanleitung
Alle Draper Messung Bedienungsanleitungen
Beliebt in Messung
Bedienungsanleitung Messung
Neueste Bedienungsanleitungen für Messung
Klein Tools ET21 Bedienungsanleitung GW Instek GPT-15001 Bedienungsanleitung GW Instek PEL-3323 Bedienungsanleitung GW Instek PSH-3630A Bedienungsanleitung GW Instek SPS-1820 Bedienungsanleitung GW Instek MDO-2204EX Bedienungsanleitung GW Instek GOS-630FC Bedienungsanleitung GW Instek MSO-2000EA Bedienungsanleitung Yato YT-28312 Bedienungsanleitung GW Instek GOM-802 Bedienungsanleitung