Drayton Digistat 2290M Bedienungsanleitung

Lies die bedienungsanleitung für Drayton Digistat 2290M (4 Seiten) kostenlos online; sie gehört zur Kategorie Thermostat. Dieses Handbuch wurde von 33 Personen als hilfreich bewertet und erhielt im Schnitt 4.4 Sterne aus 17 Bewertungen. Hast du eine Frage zu Drayton Digistat 2290M oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Programmable Room

Thermostat

Installation Guide

Digistat

3rGenerationd

(Fi3)g

3.aComplete the wiringac cording to the connction e

suggestions

shown in(Fig 3).

Model:

2290M

Technical Helpline Tel: 0333 6000 622

Website: www.draytoncontrols.co.uk

Email: customer.care@draytoncontrols.co.uk

UserndInstallationGuide06490309001Iss a E

BeforeInstallation

If you do not have the knowledge to install the thermostat

safely then you must arrange for a competent electricianor

heating egineer to install it for you. Wiring must conform to the

current IEE regulations.

Prior to commencing the installation you must ensure the

mains supply is switched off.

1. Remove the front cover by releasing the 2 screws at the

bottom. Mounting holes and electrical connections are

found underneath the hinged black cover (Fig 1).

(

Fig 1)

(Fig 2)

2. Fix back plate directly onto the wall using suitable wall plugs

and screws or mount over existing wall box (Fig 2).

(Fig 4)

3b. If your boiler supports OpenTherm please follow these

instructions:

RemovetheOpenThermcablesfrom

theexisting controlleror

thermostat. Connect the cables to the OpenThermterminals

OT1 and OT2 on th. Polarity is notimportant.e Digistat

Wire L and N from a separate supply with a 3A fuse.

Note that when connected to an OpenTherm boiler, Installer

Options 06 Valve Protection and 08 Application Type are not

available. The following options will appear in the Installer

Optionslist:

4

. Close the black hi

nged terminal cover and replace the front

cover by locating the two latches at the top then fasten the 2

screws at the bottom (Fig 4).

5. Theis now installed and will automatically start to Digistat

control the room temperature.

10 Upper CH water set point30-80°CDefault 70°C

11 Lower CH water set point10-25°CDefault 10°C

Produktspezifikationen