Electro Harmonix Neo Clone Bedienungsanleitung

Lies die bedienungsanleitung für Electro Harmonix Neo Clone (1 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 107 Personen als hilfreich bewertet und erhielt im Schnitt 5.0 Sterne aus 8 Bewertungen. Hast du eine Frage zu Electro Harmonix Neo Clone oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

NEO CLONE

FULL CHORUS

Congratulations on your purchase of the Electro Harmonix ! The Neo CloneNeo

Cloneis a compact battery operated Chorus effects pedal that features DEPTH and

RATE controls, True Bypass and an LED function indicator. To produce the Chorus

effect, the bends the frequency slightly from the input source and mixes Neo Clone

this altered signal with some direct unaffected signal. The combination produces a

doubling effect.

-OPERATING INSTRUCTIONS-

Plug your guitar into the jack and your amp into the jack, which is the INPUTAMP

Neo Clone’s output jack. Please note that as long as anything is plugged into the

INPUT, a drain is placed on your battery. It is recommended that you disconnect

the when the unit is not in use to extend battery life. INPUT

TheDEPTHswitch controls the amount of frequency change that occurs in the

altered signal. The speed of Chorus modulation is controlled by the knob. RATE

The red indicates when the effect is switched on. The footswitch toggles LED

between the Chorus effect and true bypass.

- - POWER

Power from the internal 9-volt battery is activated by plugging into the jack. INPUT

The input cable should be removed when the unit is not in use to avoid running down

the battery. If a battery eliminator is used, the Neo Clone will be powered up as long

as a wall-wart is plugged into the wall.

The barrel connector on the front of the Neo Clone is for a 9-volt battery eliminator

capable of delivering at least 25 mA of current. e optional 9V power supply from Th

Electro-Harmonix is 9.6DC-200BI (same as used by Boss™ & Ibanez™) 9.6 Volts DC

200mA. The inner ring of the 9-volt battery eliminator must be negative, the outer

ring positive. The unit’s battery may be left in or taken out when the eliminator is in

use. The actual current draw of the Neo Clone is 12 mA.

To change the 9-volt battery, you must remove the 4 screws on the bottom of the

Neo Clone. Once the screws are removed, you can take off the bottom plate and

change the battery. Please do not touch the circuit board while the bottom plate is off

or you risk damaging a component.

The input impedance presented at the Input Jack is . The output impedance at 220k

the Amp Jack is 1k. 

Produktspezifikationen