Festo DARD-L8-20-S Bedienungsanleitung

Lies die bedienungsanleitung für Festo DARD-L8-20-S (2 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 19 Personen als hilfreich bewertet und erhielt im Schnitt 4.7 Sterne aus 10 Bewertungen. Hast du eine Frage zu Festo DARD-L8-20-S oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Translation of the original instructions

LOCTITE 243

®

is a registered trademark of its respective trademark holder in cer

tain countries.

1Further applicable documents

All available documents for the product www.festo.com/pk.è

Observe further applicable documents:

–Operating instructions of the linear drive5

2Safety

2.1Safety instructions

–Before working on the product, switch off the power supply and secure it

against being switched on again.

–Observe tightening torques. Unless otherwise specified, the tolerance

is±10%. Tightening torques 5 Technical data.è

–Observe the safety data sheet for the adhesive from the original manufac

turer.

2.2Intended use

Compensating element between the slide(A) of the linear drive and the pay5

load to be moved.

3Product range overview

3.1Scope of delivery

1

Moment compensator (1x)

2

Adhesive LOCTITE 243 (1x)

3

Threaded pin (1x)

4

Screw (3x)

Fig. 1

3.2Not in scope of delivery

5

Linear drive DLGFG (1x)

Fig. 2

4Mounting

Positioning the moment compensator

Fig. 3

•Place the moment compensator opposite the sensor slot(X) flush with the1

slide(A).

Ä

The sensor slot(X) is freely accessible.

Attaching the moment compensator

Fig. 4

•Use the screws to attach the moment compensator to the slide(A). Do41

not tighten screws.4

Mounting the moment compensator

Fig. 5

1.Apply adhesive to the threaded pin.23

2.Screw the threaded pin into the moment compensator.31

3.Tighten the threaded pin.3

4.Tighten the screws.4

4.1Mounting the payload

Hole for spring pin(B)

Fig. 6

•Hole for spring pin(B) provided for centring the payload.

Recommended hole for spring pin(B): 5.2Æ

+0.1

mm

Mounting the payload on DARD-L8-20/25-S

Fig. 7

•Mount payload with recommended screws using hole(C) or(D) on the

moment compensator.1

Hole(C)Hole(D)

Hole threadM5M5

Recommended screws 2xM58.82xM48.8 ISO4762ß

Recommended tightening torques[Nm]4.52.6

Tab. 1

When mounting the payload using hole(D), the threaded holeM5(C) serves as a

through hole for the screwM4.

8084730

Moment compensator

DARD-L8

8084730

201802a

[8084732]

Instructions| Assembly

Festo SE & Co. KG

Ruiter Straße 82

73734 Esslingen

Germany

+49 711 3470

www.festo.com

Produktspezifikationen