Forte Lighting 2758-01 Bedienungsanleitung

Lies die bedienungsanleitung für Forte Lighting 2758-01 (2 Seiten) kostenlos online; sie gehört zur Kategorie Beleuchtung. Dieses Handbuch wurde von 3 Personen als hilfreich bewertet und erhielt im Schnitt 4.4 Sterne aus 4 Bewertungen. Hast du eine Frage zu Forte Lighting 2758-01 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Page 1 of 2

INSTALLATION INSTRUCTIONS

Model# 2758-01

1 LIGHT PENDANT

! Warnings and Cautions

Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if you are

in doubt.

These instructions are provided for your safety. It is very important you read them completely before installing

fixture. We strongly recommend that a licensed, professional electrician perform the installation.

Turn off the fixture at the wall switch before replacing bulbs.

- Make sure bulbs are given sufficient time to cool before removal.

- Do not subject glass parts to any shock while in operation or shattering may result.

Tools Required (Not Included): Flathead screwdriver, Phillips screwdriver, Wire cutters, Electrical tape, Safety

goggles, Ladder.

Helpful Tools (not included): Wire strippers.

ASSEMBLY INSTRUCTIONS

1.Carefully unpack and lay all parts on a clean, level

surface. Do not discard any contents until after

assembly is complete to avoid accidentally

discarding small parts or hardware.

2.Attach the threaded end of the short stem (k) into

socket assembly (L), turning the stem in a

clockwise direction till tight. Unscrew the

pre-assembled lock ball nut (G) from the mounting

bracket (B). Attach the mounting bracket (B) to the

junction box (not included) with junction box screws

(D).

3.Loosen the Allen Strain Relief Screw (H) from the

threaded collar using the Allen Wrench (I) by

turning the wrench counter-clockwise. Adjust the

Power Cord (J) upwards or downwards through the

canopy (F) until the desired suspension length is

determined. Secure the power cord (J) in place by

tightening the set screw in a clockwise motion (H)

onto the collar. Do not over tighten the screw,

making sure the power cord (J) will not slip

downwards with the pendant body.

A

E

D

C

G

B

F

Produktspezifikationen