Furuno FAPAR4502 Bedienungsanleitung

Lies die bedienungsanleitung für Furuno FAPAR4502 (2 Seiten) kostenlos online; sie gehört zur Kategorie Marine. Dieses Handbuch wurde von 29 Personen als hilfreich bewertet und erhielt im Schnitt 4.6 Sterne aus 15 Bewertungen. Hast du eine Frage zu Furuno FAPAR4502 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Beforeyoudoityour way,

please try it our way

TELEFLEX CANADA

3831 NO.6 ROAD

RICHMOND, B.C.

CANADA V6V 1P6

FAX 604-270-7172

www.seastarsteering.com

© 2005 TELEFLEX CANADA LIMITED PARTNERSHIP

PRINTED IN CANADA

FORM NO. 269064 - 03/06 Rev C

ISO 10592

INSTALLATION INSTRUCTIONS

SUPPLEMENTAL

20

Autopilot Rudder Reference

SMART

STICK

ISO 9001

MANUFACTURED BY

TELEFLEX CANADA LIMITED

PARTNERSHIP

HYDRAULIC

INSTALLATION INSTRUCTIONS

1Remove the nuts and washers

(item 1 & 2) from the steering

cylinder rod. Discard washers

(item 2) as they will not be used

in the SmartStick installation.

2Install brackets (item 3) onto the

ends of the cylinder support rod.

Re-install the nuts (item 1) and

torque to 33 in. lb. (3.82 Nm).

3Install the sensor (item 4) behind

the brackets as shown in figures

A and B.

4Mount the magnet (item 5) to the

center of the cylinder body with the

arrow pointed in the same direction

as the arrow on the sensor.

5Turn steering cylinder so that the

magnet arrow and the sensor decal

arrow are nearest each other.

6Without changing the position

along the length of the cylinder,

rotate the magnet on the cylinder

so that the arrows on the sensor

and magnet are as closely lined

up as possible.

7Tighten band clamp to 3 in. lb.

(0.35 Nm) to secure the magnet

in position.

Correct installation of the magnet

is important to the overall

operation of the autopilot.

Over tightening clamp may cause

magnet to break.

8Connect Rudder Reference to

autopilot as per autopilot instal-

lation instructions. Refer to Table

1 to ensure correct application

9Move the steering cylinder from

hard over to hard over to confirm

that the autopilot receives a

signal from the sensor at ALL

cylinder positions.

10

Install Strain relief (item 6).

Failure to install the strain relief

may result in irreparable damage

to the sensor.

NOTICE NOTICE

NOTICE

TOOLS REQUIRED

5/8" Wrench5/16" Wrench

11/32" Wrench3/32" Allen Key

Torque Wrench

Produktspezifikationen