Insignia NS-LED8CT22 Bedienungsanleitung

Lies die bedienungsanleitung für Insignia NS-LED8CT22 (2 Seiten) kostenlos online; sie gehört zur Kategorie Beleuchtung. Dieses Handbuch wurde von 63 Personen als hilfreich bewertet und erhielt im Schnitt 5.0 Sterne aus 32 Bewertungen. Hast du eine Frage zu Insignia NS-LED8CT22 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Before using your new product, please read these instructions to prevent any damage.

SETTING UP YOUR LIGHTSTRIP

Shortening your lightstrip

1Decide how long you need your lightstrip to be. When

measuring, make sure that you start from the side of the

tape that has the controller box connected to it. The part of

the tape that you cut o will no longer light up.

2Locate the nearest cut line, and cut with a pair of scissors.

Cut lines are about 1.3 in. (3.3 cm) apart.

: Do not cut the silver solder markings. Only cut in the WARNING

center of the copper-colored pads, as shown.

PACKAGE CONTENTS

• LED lightstrip

• USB power supply

• Cable clips (2)

• Quick Setup Guide

FEATURES

• 16 selectable colors provide accent or ambient lighting

• 8 ft. LED lightstrip can be cut to your ideal length

• Self-adhesive back attaches to TVs, cabinets, or other locations

for custom lighting

• Multi-step dimmer adjusts to the brightness level you want

• Strobe and color fade modes create fun lighting eects from

any USB port

QUICK SETUP GUIDE

8 ft. RGB

LED Lightstrip

NS-LED8CT22

USB

connectorWire

LED

lightstrip

M

COLOR

BRIGHT

Cut

line

Cut line

Attaching your lights

Adhesive backing

Note: You can secure your lightstrip in place with its adhesive

backing or cable clips.

CAUTION: To avoid damage to the lightstrip, do not sharply twist or

bend the lightstrip 90° or more.

1Peel the adhesive backing o the lights, then attach the

lights where you want them.

2Optional: Attach the double-sided tape (not included) to the

back of the light control, then attach it where you want it.

Notes:

• Make sure that the lightstrip is unrolled, otherwise it can

damage the lightstrip or cause a re.

• Every surface is dierent, and additional adhesive may be used

if the LED tape detaches from the surface. Small pieces of clear

tape can be used.

Cable clips

1Make sure that your mounting location is clean, dry, and

free of oils.

2 Remove the adhesive backing on a cable clip, and push it

rmly where you want to mount your lightstrip.

3Align the lightstrip with the cable clip.

4Slide the cable clip through the buckle and pull to tighten.

5Repeat steps 1-4 to attach the second cable clip.

WARNING: Unroll before use. Never plug in the LED

lights when rolled up, as this can result in product

damage or a re.

COLOR

BRIGHT

Light controls

Change color

Turn on/o

Change mode

Adjust

brightness/speed

Cable clip

Adhesive back

Wire

Produktspezifikationen