Jacuzzi ST04827 Bedienungsanleitung

Lies die bedienungsanleitung für Jacuzzi ST04827 (3 Seiten) kostenlos online; sie gehört zur Kategorie Wasserhahn. Dieses Handbuch wurde von 3 Personen als hilfreich bewertet und erhielt im Schnitt 4.5 Sterne aus 3 Bewertungen. Hast du eine Frage zu Jacuzzi ST04827 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

SHOWERHEAD INSTALLATION GUIDE

Jacuzzi Item / #ST04826-BN / ST04827-CP

#ST05826-BN / ST05827-CP

#ST06826-BN / ST06827-CP

Questions, problems, missing parts?Before returning to

your retailer, call our customer service department at

1---4002, 9 a.m. -5 p.m., EST, Monday -Friday.800288

ATTACH YOUR RECEIIPT HERE

Purchase Date _______________

CAUTION-TIPS FOR REMOVAL OF OLD SHOWERHEAD:

Always turn off water supply before removing existing

showerheador replacing any part. Open the valvehandle

to relieve water pressure and ensure that water is

completely shut o.

CARE INSTRUCTIONS:

To preserve the finish of your showerhead, apply -non

abrasive wax. Any cleaners should be rinsed off

immediately. Do not use abrasive cleaners on the

showerhead.

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate, or install the

products.

WARNING:

•Follow the installation instructions carefully. Proper installation is the installer’s responsibility.

•Failure to follow correct installation procedures can result in the showerhead being loose, which can

result in serious injury.

CAUTION:

•Check local building codes before beginning installation to ensure compliance.

PACKAGED CONTENT

Tools Required for Assembly

Thread Sealant Tape

Wrench

Remove the old showerhead

from the existing shower arm by

turning the ball joint

counterclockwise.

Apply thread sealant tape in a

clockwise direction to the open

end of the shower arm.

Flush the lines without the

showerhead to remove debris

before installing showerhead.

Carefully use a wrench on the

thread ats of the ball joint

to tighten. Do not overtighten.

Meets ASME A112.18.1M Requirements 1.8gpm (6.8L/min) Max, 1.35gpm (5.1L/min) Min at 45psi

PARTDESCRIPTIONQUANTITY

AShowerhead1

TROUBLESHOOTING

1

2

3

4

PART NO: ST11000 Rev A

ST06XXX

ST04XXX

ST05XXX

PROBLEMPOSSIBLE CAUSECORRECTIVE ACTION

Uneven water ow

Water nozzles are blocked with mineral

build

-up or debris

Gently rub easy clean nozzles with ngertip to remove

any mineral build

-up or debris

Low water ow

Mineral build

-up or debris have clogged

the screen in the ball joint

Rinse the mineral build

-up or debris from the screen

A

Produktspezifikationen