Jacuzzi ST09827 Bedienungsanleitung

Lies die bedienungsanleitung für Jacuzzi ST09827 (1 Seiten) kostenlos online; sie gehört zur Kategorie Wasserhahn. Dieses Handbuch wurde von 3 Personen als hilfreich bewertet und erhielt im Schnitt 4.5 Sterne aus 6 Bewertungen. Hast du eine Frage zu Jacuzzi ST09827 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

HANDHELD SHOWERHEAD INSTALLATION GUIDE

Jacuzzi Item / #ST07826-BN / ST07827-CP

#ST08826-BN / ST08827-CP

#ST09826-BN / ST09827-CP

#ST10826-BN / ST10827-CP

Questions, problems, missing parts?Before returning to

your retailer, call our customer service department at

1---4002, 9 a.m. -5 p.m., EST, Monday -Friday.800288

ATTACH YOUR RECEIIPT HERE

Purchase Date _______________

CAUTION-TIPS FOR REMOVAL OF OLD

SHOWERHEAD:

Always turn off water supply before removing existing

showerheador replacing any part. Open the valve

handle to relieve water pressure and ensure that water

is completely shut o.

CARE INSTRUCTIONS:

To preserve the finish of your showerhead, apply

non-abrasive wax. Any cleaners should be rinsed o

immediately. Do not use abrasive cleaners on the

showerhead.

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate, or install the

products.

WARNING:

•Follow the installation instructions carefully. Proper installation is the installer’s responsibility.

•Failure to follow correct installation procedures can result in the showerhead being loose,

which can result in serious injury.

CAUTION:

•Check local building codes before beginning installation to ensure compliance.

Tools Required for Assembly

Thread Sealant Tape

Wrench

Meets ASME A112.18.1M Requirements 1.8gpm (6.8L/min) Max, 1.35gpm (5.1L/min) Min at 45psi

PARTDESCRIPTION

QUANTITY

AShowerhead1

B

Hand Shower Holder

1

C1Hose 60”

TROUBLESHOOTING

A

Install the hex nut of the hose to the

hand shower holder. Carefully use a

wrench on the thread atsDo not .

overtighten.

PART NO: ST12000 Rev A

Remove the old showerhead

from the existing shower arm by

turning the ball joint

counterclockwise.

1

Apply thread sealant tape in a

clockwise direction to the open

end of the shower arm.

2

PROBLEMPOSSIBLE CAUSECORRECTIVE ACTION

Uneven water ow

Water nozzles are blocked with mineral

build

-up or debris

Gently rub easy clean nozzles with ngertip to remove

any mineral build

-up or debris

Low water ow

Mineral build

-up or debris have clogged

the screen in the ball joint

Rinse the mineral build

-up or debris from the screen

ST09XXX

ST07XXX

ST08XXX

ST10XXX

PACKAGED CONTENT

B

C

Install the hand shower holder.

Flush the lines without the

showerhead to remove debris

before installing showerhead.

3

Install the handheld showerhead to

the conical nut of the hose. Carefully

hand tighten on the thread ats.Do

not overtighten.

4

5

6

Produktspezifikationen