Klark Teknik DI 10P Bedienungsanleitung
Klark Teknik
Nicht kategorisiert
DI 10P
Lies die bedienungsanleitung für Klark Teknik DI 10P (1 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 31 Personen als hilfreich bewertet und erhielt im Schnitt 4.0 Sterne aus 16 Bewertungen. Hast du eine Frage zu Klark Teknik DI 10P oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/1

PRO DI 10P
Passive DI Box with Stereo Input / Summed Mono Output,
MIDAS Transformer and Extended Dynamic Range
INPUTS – Connect your source audio via stereo RCA jacks or a single ⁄" TRS jack. The unused input jack can act as a loop-through output. A mono source can also be connected to one
of the RCA jacks, or to the ⁄" input.
LEVEL L/R – The level of the left and right channels can be adjusted before being sent to the output jack. Normally these knobs should be set fully clockwise, but may be used to
attenuate very hot signals, or to correct the balance between the channels.
OUTPUT – Send the summed inputs to a mixing console via balanced XLR cable. The output level is approximately 20 dB lower than the input signal.
EARTH LIFT – This switch may help reduce unwanted hum by removing the ground connection.
Speci cations
Inputs
Connectors RCA unbalanced, ⁄ TRS
Impedance 7 k
Outputs
Connector XLR , balanced
Impedance 170
System
Frequency response 10 Hz to 91 kHz (± 1 dB)
THD + N (distortion) <0.03% @ 1 kHz, +4 dBu
Signal-to-noise ratio >120 dB @ 1 kHz, +4 dBu
Power requirement Passive
Physical
Dimensions (WxDxH) 64 x 118 x 112 mm
(2.5 x 4.7 x 4.4")
Weight 0.47 kg (1.0 lbs)
klarkteknik.com
LEGAL DISCLAIMER
MUSIC Group accepts no liability for any loss which may be su ered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein.
Technical speci cations, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. MIDAS, KLARK TEKNIK,
LAB GRUPPEN, LAKE, TANNOY, TURBOSOUND, TC ELECTRONIC, TC HELICON, BEHRINGER, and BUGERA are trademarks or registered trademarks of MUSIC Group IP Ltd.
© MUSIC Group IP Ltd. 2017 All rights reserved.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information regarding MUSIC Group’s Limited Warranty, please see complete details online at
music-group.com/warranty.
Produktspezifikationen
Marke: | Klark Teknik |
Kategorie: | Nicht kategorisiert |
Modell: | DI 10P |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Klark Teknik DI 10P benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Klark Teknik
9 Juni 2025
23 August 2024
23 August 2024
23 August 2024
23 August 2024
23 August 2024
23 August 2024
23 August 2024
23 August 2024
23 August 2024
Bedienungsanleitung Nicht kategorisiert
- Code Mercenaries
- Urbanista
- Zanussi
- Redback Technologies
- Cabstone
- LOQED
- Newland
- OP/TECH
- Aqua Computer
- Neets
- Levenhuk
- Axxess
- Meopta
- VAVA
- Sungrow
Neueste Bedienungsanleitung für -Kategorien-
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025