Marshall Electronics CV-RCP-V2 Bedienungsanleitung

Lies die bedienungsanleitung für Marshall Electronics CV-RCP-V2 (37 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 47 Personen als hilfreich bewertet und erhielt im Schnitt 4.7 Sterne aus 6 Bewertungen. Hast du eine Frage zu Marshall Electronics CV-RCP-V2 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

__________________________________________________________________________________________________

CV-RCP-V2 Camera Control Unit

Mul-Camera Setup & Tips

The Marshall CV-RCP-V2uses Sony VISCA (RS485) commands sent over 3-pin XLR (copper) cable with exibility to run

300+ meters (1,000’) to each camera locaon. This length can be extended much longer when converng to ber using

common media converters that support RS485 control commands. Some ber media converters support RS485

command (only) and some support both RS485 command & 3G/HD-SDI video over one ber cable. It really depends on

the specic project setup requirements which one to use.

3-pin XLR cable

Y-split at each

camera

At each camera posion;

splice raw copper wire into

2-pin phoenix connector on

breakout cable or into rear

camera

panel

of camera

3-pin XLR splier boxes

can also be used (1 to 3, 1

to 5, 1 to 7), up to seven

cameras per RCP unit.

CV-RCP-V2-RMKrack

mounts also available to

drop into CCU control

boards or broadcast trucks

As long as copper ends of

RCP match Camera; + to +

and - to -, then RCP will

connect and control Cameras

(pictured below plugged into

cable break

out

Size & shape designed to

drop into a CCU camera

control panel

Light and portable

enough to travel to each

broadcast event in a hard

carry case to remotely

adjust & match POV

cameras at each event

from the truck

On Marshall CV343/505

models the raw XLR

copper wire plugs

directly into rear panel.

Produktspezifikationen