Metra LC-GMRC-LAN-10 Bedienungsanleitung
Metra
Nicht kategorisiert
LC-GMRC-LAN-10
Lies die bedienungsanleitung für Metra LC-GMRC-LAN-10 (8 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 16 Personen als hilfreich bewertet und erhielt im Schnitt 4.7 Sterne aus 8.5 Bewertungen. Hast du eine Frage zu Metra LC-GMRC-LAN-10 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/8
LC-GMRC-LAN-10
I N S TA L L AT I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2019 METRA ELECTRONICS CORPORATION REV. 11/18/19 INSTLC-GMRC-LAN-10
Product Info
INTERFACE COMPONENTS
OPTIONAL ACCESSORIES (sold separately)
Extension Harness: AX-GMLAN10EXT
TABLE OF CONTENTS
Connections ............................................................2
Installation .............................................................3
Programming .........................................................3
APPLICATIONS
CHEVROLET
Colorado 2017-2019(1)
Cruze 2016-2019(2)
Cruze Hatchback 2016-2019(2)
Equinox 2019(1)
Malibu 2016-2019(2)
Silverado 2016-2019(1)
GMC
Canyon 2017-2019(1)
Sierra 2016-2019(1)
• LC-GMRC-LAN-10 interface
• LC-GMRC-LAN-10 harness
• (1) With RPO code I0B With RPO code I0A • (2)
The IOA/IOB code, if applicable, can be found in the Service Parts Identification label located:
Glovebox: Canyon/Colorado/Cruze/Equinox/Silverado/Sierra – Rear Compartment Floor: Malibu
INTERFACE FEATURES
GM Data Interface 2016-2019
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
•
Provides illumination, parking brake, reverse, and speed sense outputs
• Used in non-amplified models, or when bypassing a factory amp
• Retains the factory backup camera
• Used in models without OnStar
• Retains all warning chimes
• High level speaker input
• Retains balance and fade
• Micro-B USB updatable
TOOLS & INSTALLATION ACCESSORIES REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrink • Tape • Wire cutter
• Zip ties
2
CONNECTIONS
From the LC-GMRC-LAN-10 harness to the aftermarket radio, connect the:
• wire to the ground wire.Black
• Yellow wire to the battery wire.
• wires (2) to the accessory wire.Red
• Blue/White wire to the amp turn on wire (excluding Bose). This wire must be connected to
hear sound from the factory amplifier.
• Orange wire to the illumination wire (if applicable).
• White wire to the front left positive speaker output.
• White/Black wire to the front left negative speaker output.
• wire to the front right positive speaker output.Gray
• Gray/Black wire to the front right negative speaker output.
• Green wire to the rear left positive speaker output.
• Green/Black wire to the rear left negative speaker output.
• wire to the rear right positive speaker output.Purple
• wire to the rear right negative speaker output.Purple/Black
The following (3) wires are only for multimedia/navigation radios that require these wires.
• wire to the VSS/speed sense wire.Blue/Pink
• Green/Purple wire to the reverse wire.
• Light Green wire to the parking brake wire.
• Yellow RCA jack to the backup camera input. (If the vehicle is equipped with a factory backup
camera.)
3
REV. 11/18/2019 INSTLC-GMRC-LAN-10
INSTALLATION
PROGRAMMING
With the key in the off position:
1. Locate the factory radio harness in the vehicle and complete all necessary connections to the
aftermarket radio.
2. Connect the LC-GMRC-LAN-10 harness LC-GMRC-LAN-10 interface to the , and then to the
factory radio harness in the vehicle.
Note: For the Equinox and Malibu, use part number AX-GMLAN10EXT (sold separately) to extend
the wiring harness to the right of the glovebox where the radio brain is located at.
Attention: If the interface loses power for any reason, the following steps will need to be
performed again.
1.
Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on
.
If the radio does not come on within 60 seconds, turn the key to the off position, Note:
disconnect the interface, check all connections, reconnect the interface, and then try again.
2. Cycle the key off, then back on. If the driver’s door is closed, open and close the door.
3. Test all functions of the installation for proper operation, before reassembling the dash.
Note: The vehicle must be running for the factory camera to power on.
Produktspezifikationen
| Marke: | Metra |
| Kategorie: | Nicht kategorisiert |
| Modell: | LC-GMRC-LAN-10 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Metra LC-GMRC-LAN-10 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Metra
15 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
1 Juli 2025
27 Juni 2025
8 Juni 2025
8 Juni 2025
Bedienungsanleitung Nicht kategorisiert
- Danby
- Furman
- Reer
- Bimar
- Witt
- Powertec
- Dnipro
- Ikarao
- LISEN
- Swingline
- Seidio
- Tandberg Data
- Potenza
- Harley Benton
- Butler
Neueste Bedienungsanleitung für -Kategorien-
30 Juli 2025
30 Juli 2025
30 Juli 2025
30 Juli 2025
30 Juli 2025
30 Juli 2025
30 Juli 2025
30 Juli 2025
30 Juli 2025
30 Juli 2025