Mikrotik LHG XL HP5 Bedienungsanleitung

Lies die bedienungsanleitung für Mikrotik LHG XL HP5 (3 Seiten) kostenlos online; sie gehört zur Kategorie Zugangspunkt. Dieses Handbuch wurde von 36 Personen als hilfreich bewertet und erhielt im Schnitt 4.6 Sterne aus 6 Bewertungen. Hast du eine Frage zu Mikrotik LHG XL HP5 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

LHG series

Quick Setup Guide and Warranty Information

The LHG is an outdoor wireless router with a built in directional antenna. It can be used as a CPE or for point to point links (use RouterOS

wireless mode “bridge” to work as a single-client AP for point to point scenarios).

Assembly

Attach the two legs to the LHG case, then snap the assembed LHG unit to the grid in the appropriate locations. Fix the legs in place with two

self thread screws (Included, use philips screw driver PH2). The package also contains a grounding cable connector, and a 5 degree angle

adapter. More detailed instructions available on the product page on http://routerboard.com

Connecting

1.Open the ethernet door to connect an ethernet cable to the ethernet port, connect the other end of the ethernet cable to the included

PoE injector

2.Plug the PoE injector into your network switch or ISP internet outlet

3.Plug the included power supply into the PoE injector to start up the device

4.Set LAN computer IP configuration to (DHCP)automatic

5.Default IP address of the unit is 192.168.88.1, open this address in your web browser to start configuration. The username is admin

and there is no password

The device is preconfigured as a wireless client, and all you need to do is select the AP to connect to and set a device password. You can do

this in the quickSET tab that is loaded by default.

In case IP connection is not available, Winbox can be used to connect to the MAC address of the device.

In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the RESET button of the device when starting it,

until the LED light turns off, then the device will start to look for Netinstall servers.

More information about using RouterOS and connecting to this device in our documentation: http://mt.lv/help

Powering

The device accepts powering only from Passive PoE injectors

Extension Slots and Ports

One 10/100 Ethernet port, supporting automatic cross/straight cable correction (Auto MDI/X), so you can use either straight or cross-

over cables for connecting to other network devices.

One Integrated 2x2 MIMO wireless device with built in grid antenna

Buttons and Jumpers

RouterBOOT reset button (RESET, front panel) has three functions:

•Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS configuration (total 5 seconds)

•Keep holding for 5 more seconds, LED turns solid, release now to turn on CAPs mode (total 10 seconds)

•Or Keep holding the button for 5 more seconds until until LED turns off, then release it to make the RouterBOARD look for Netinstall

servers (total 15 seconds)

Power on device with pressed reset button and release it right away in order to boot backup RouterBOOT (useful for debugging situations where

RouterOS and Netinstall do not work).

The device includes a grounding connection (marked ) which you should connect to the grounding installation of the tower or building where ⏚

the device will be used. This is to substantially reduce risk of ESD and lightning damage.

Operating System Support

Currently tested operating system is MikroTik RouterOS starting from version v6.38

See www.routerboard.com for more information. Contact support@mikrotik.com 9-Jun-17

Produktspezifikationen