Monacor KP70-400 Bedienungsanleitung

Lies die bedienungsanleitung für Monacor KP70-400 (3 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 16 Personen als hilfreich bewertet und erhielt im Schnitt 4.5 Sterne aus 8.5 Bewertungen. Hast du eine Frage zu Monacor KP70-400 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Manufactured by :

CRC Industries Europe BVBA

Touwslagerstraat 1 – 9240 Zele – Belgium

Tel (32) (0) 52/45.60.11 Fax (32) (0) 52/45.00.34

www.crcind.com

TECHNICAL DATA SHEET

1/3

PLASTIK 70

Ref. : 20743

1. GENERAL DESCRIPTION

Quick drying, colorless transparent insulating and protective coating based on acrylic resins.

2. FEATURES

•PLASTIK 70 is a low viscosity, solvent drying acrylic based conformal coating with

excellent insulating properties. The lacquer is colorless transparent and elastic. It has a

durable adhesion in the temperature range from –40°C to +60°C and can be used for a

short period of time up to +100°C maximum. It protects printed circuit boards and

surfaces from humid inorganic-acid or caustic vapors.

•PLASTIK 70 is colorless-transparent and as such is not visual on the printed circuit board

surface.

•Contains “moisture warning”: To avoid involuntary encapsulations of moisture, Plastik 70

will warn you when applied on a humid surface, by showing a frosted, mat appearance.

•For repair works PLASTIK 70 can be soldered through or be totally removed with

acetone, THINNER FOR PLASTIK 70.

3. APPLICATIONS

PLASTIK 70 was specially developed to protect printed circuit boards. It overcomes electrical

leakages and short circuits.

As a low viscosity xing and insulating lacquer, PLASTIK 70 can also be used as extra/after

insulation of coils and transformers and overcomes disturbing noises.

PLASTIK 70 can also be used as a universal protective coating on any surface like metal,

paper, ornaments, paintings, furniture, etc.

4. DIRECTIONS

•For small runs and service applications, the easiest way to apply PLASTIK 70 is from an

aerosol can. Spray from a distance of 20 to 30 cm on the dry and degreased surface. As

pre-cleaning of PCB’s, we do recommend the use of KONTAKT PCC to remove greases,

dirt and ux residues. When nished spraying, clean the aerosol valve by turning the can

upside down and pressing the button until only propellant escapes.

•For serial production runs, PLASTIK 70 in bulk can be applied by brush or by dipping. For

spraying, two parts per volume PLASTIK 70 is diluted with up to one part of THINNER

FOR PLASTIK 70. The precise mixing ratio must be determined by trials with the

equipment concerned.

•For dip coating it is also necessary to x the immersion time and the withdrawal speed.

The faster the removal from the bulk, then thicker the lm will be. Dipping baths have to

be carefully protected to ensure no entrapment of conductive stuck-on residues.

Produktspezifikationen