Prestige APSSEC Bedienungsanleitung
Prestige
Nicht kategorisiert
APSSEC
Lies die bedienungsanleitung für Prestige APSSEC (25 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 4 Personen als hilfreich bewertet und erhielt im Schnitt 4.3 Sterne aus 2.5 Bewertungen. Hast du eine Frage zu Prestige APSSEC oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/25
Installaon and Reference Guide
2020 Voxx Electronics Corporaon. All rights reserved. APSSEC_RevC_07/20
2 Wire Harness Colors and Funcons
2 Power / Nocaon Connector
3 Input / Output Connector
6 External Components
6 Shock Sensor
6 RF Antenna Kit
6 Data Bus Interface (DBI)
6 Telemacs
7 Setup Opons
7 Remote Programming
8 Security Control
12 Negave Output Control (NOC)
14 AUX Output Control
15 PIC Input Control
16 System Operaon
16 Remote Operaon
APSSEC
Vehicle Security / Keyless Entry System
17 System Programming
17 Programming Mode Entry / Exit
18 Feature Bank Opons
18 Data Port Protocol Selecon
19 Dome Light
19 Silent Arm and Disarm
19 User Selectable LED
19 System Diagnoscs
19 Troubleshoong Trigger Zones
19 Adjusng Shock Sensor
20 Alarm Override Procedures
21 Wiring Diagrams
21 Door Lock Connecons
24 Starter Kill Relay
25 Full System Connecons
Thank you for trusng Presge products! If you are a consumer, please note:
Professional installaon is strongly recommended.
This manual assumes the installer has adequate knowledge of the following experse. Therefore, it does not
cover these topics in detail:
• 12-volt electronics
• Tesng and verifying circuits
• Making safe and lasng wiring connecons
• Factory ignion, power, lighng, data bus and sensing systems
• Factory systems and components to avoid
• Safe wire roung, circuit protecon and product placement
• Access to vehicle-specic technical informaon
In addion, this manual assumes the installer has the proper tools, skill and facilies to perform a professional installaon.
Performing an improper installaon could result in damage to the vehicle or its components, improper system funcon,
unsafe vehicle operaon or physical injury. Such instances would not be covered by the vehicle manufacturer's warranty,
nor by Voxx Electronics, Inc.
Detailed Descripons Quick Reference
APSSEC_RevC_07/20
2
Detailed Descripons: Wire Harness Colors and Funcons
4. YELLOW – Ignion Input (+)
The YELLOW wire connects to the vehicle's primary ignion wire. This wire will be used for system programming and
override.
Vericaon: This ignion wire registers 12-Volt (+) when the key is in the accessory, ignion, and start posions.
Note: Before making this connecon, remove all module fuses unl the system is completely connected.
6. RED – 12-Volt Input (+)
The RED wire connects to the vehicle’s primary 12-Volt (+) wire to power the system.
Vericaon: The power wire registers 12-Volt (+) at all mes.
Note: Before making this connecon, remove all module fuses unl the system is completely connected.
1 3 5
2 4 6
Power / Nocaon Connector (6-pin connector) See page 25 for the full system diagram.
These wires are listed in order of their placement in the harness connector.
3. WHITE/RED – Parking Light Relay Input (Internal Relay Pin 87)
The WHITE/RED connects to vehicle 12-Volt (+) or Ground (-) to supply the relay output (WHITE wire).
Vericaon for default seng:
• If the vehicle parking light wire registers 12-Volt (+) when the park lights are on, connect the WHITE/RED wire to a
constant 12-Volt (+) vehicle wire.
• If the vehicle parking light wire registers Ground (-) when the park lights are on, connect the WHITE/RED wire to a
reliable vehicle ground source.
Note: This wire can be programmed to perform the Trunk Release Output funcon by changing its opons. Refer to
Bank 2, Feature 14 on page 8.
1. WHITE – Parking Light Relay Output (Internal Relay Pin 30)
At its default seng, the WHITE wire supplies 12-Volt (+) or Ground (-) to the vehicle's park light wire based on the
connecon of the relay input (WHITE/RED wire).
Vericaon: The vehicle parking light wire registers 12-Volt (+) or Ground (-) when the park lights are turned on.
Note: This wire can be programmed to perform the Trunk Release Output funcon by changing its opons. Refer to
Bank 2, Feature 14 on page 8.
2. BLACK – Ground Input (-)
The BLACK wire connects to a reliable vehicle ground (-) source to power the system.
Vericaon: The vehicle ground (-) source wire registers ground (-) at all mes.
Note: Before making this connecon, remove all module fuses unl the system is completely connected.
5. WHITE/BLACK – Siren Output (+)
The WHITE/BLACK wire supplies 12-Volt (+) to power the siren. Aer mounng the siren, connect its BLACK wire to a
reliable ground source, and connect the BROWN wire to the siren’s RED wire.
Produktspezifikationen
| Marke: | Prestige |
| Kategorie: | Nicht kategorisiert |
| Modell: | APSSEC |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Prestige APSSEC benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Prestige
1 August 2025
1 August 2025
1 August 2025
Bedienungsanleitung Nicht kategorisiert
- Vollrath
- Artex
- Steffen
- BaByliss
- Newport Brass
- Roco
- Scancool
- Cambridge
- Sinus Live
- SteelSeries
- Salora
- Genexis
- Sonuus
- Arovec
- Excalibur
Neueste Bedienungsanleitung für -Kategorien-
6 August 2025
6 August 2025
6 August 2025
6 August 2025
6 August 2025
6 August 2025
6 August 2025
6 August 2025
6 August 2025
6 August 2025