Rane AP 13 Bedienungsanleitung
Lies die bedienungsanleitung für Rane AP 13 (6 Seiten) kostenlos online; sie gehört zur Kategorie Mischer. Dieses Handbuch wurde von 2 Personen als hilfreich bewertet und erhielt im Schnitt 3.5 Sterne aus 1.5 Bewertungen. Hast du eine Frage zu Rane AP 13 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/6
AP 13
ACOUSTIC PREAMPLIFIER
BA
CUT
RING=MIC RING=PIEZO –
PIEZO
PICKUP GAIN TRIM
PHANTOM
TIP=PIEZO TIP=MIC
15V6V
POWER
INPUT 101010 A12
10
0
INVERT INVERT
180
250
12
9
6
80
3
MIC
6
3
35
9
20
C
2
0
4
1802
B 0 250
4 80
6
8
6 35
8 20
LOW
+
CUT 40 100 250 OUT630 1.6k 10k4k LEVELPAN
LOW
–
6
10
4
101010A12
C0
12
9
6
3
B
6
3
9
222
0 0 0
4 4 4
0
6 66
8 8 8
2
630100
+
40 250 1.6k 4k 10k PAN SEND
LEVEL A B RTN LEVEL
0 10
28 8
4 6
LEVEL
13AP
PZO
MIC
OL
INSTRUMENT PIEZO PICKUP
POWER
MUTE
MIC PICKUP MAIN OUT
PREAMPLIFIER
OL
ACOUSTIC
HEADPHONE
108367
IMPORTANT SAFETY INSTRUCTIONS
For the continued safety of yourself and others we recommend that you read the following
safety and installation instructions. Keep this document in a safe location for future reference.
Please heed all warnings and follow all instructions.
Do use this equipment in a location where it might become wet. Clean only with a damp not
cloth.
is equipment may be installed in an industry standard equipment rack. We recommend that
all mounting holes be used, providing the best physical support. e equipment may be used as
a table top device, although stacking of the equipment is dangerous and not recommended.
Do not directly block any of the ventilation openings. If rackmounting, please provide adequate
ventilation. Equipment may be located directly above or below this unit, but note that some
equipment (like large power amplifiers) may cause an unacceptable amount of hum or may
generate too much heat and degrade the performance of this equipment.
Protect the power cord and plug from damage caused by being walked on or pinched. Protect
the line cord, where it exits the unit, from excessive strain. Only use attachments and acces-
sories specified by Rane.
Unplug this equipment during lightning storms or when unused for long periods of time.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as power supply cord or plug damage, spilled liquid, fallen
objects into an opened chassis, exposure to rain or moisture, a dropped unit, or abnormal
operation.
Manual-1
OPERATORS MANUAL AP 13
ACOUSTIC PROCESSOR
QUICK START
The AP 13 accommodates the signals from two pickups from any acoustic instrument, where the pickups are wired to
the tip and ring of a standard stereo ¼" TRS (Tip, Ring, Sleeve) plug. You do not need internal preamps when using the
AP 13. Phantom power voltage is available for electret and other condenser mic pickups. It is assumed one pickup is a
piezo-type while the other is some type of microphone.
1. Slide the Input Wiring switch to the correct position agreeing with your pickup wiring situation.
2. If your mic pickup requires Phantom Power, select it using the switch on the AP 13 rear. Make sure the appropriate LED
lights by the INPUT jack.
3. Turn the MAIN OUT LEVEL controls down.
4. Connect the AP 13 to your amplifier using the ¼" MAIN OUTPUTS or use the HEADPHONE jack.
5. Initially, turn the PIEZO and MIC PICKUP GAIN TRIM controls half way up.
6. Move each LOW CUT slider to the top (15 Hz); center all EQ sliders; center the PAN sliders; leave the INVERT
pushbuttons out; and position the LEVEL sliders to “4”
7. Plug your instrument into the INPUT jack on the front of the AP 13 with a stereo ¼" TRS cable.
8. Power up the AP 13, then turn on your amplifier.
9. Play your instrument and slowly turn up the MAIN OUT LEVEL controls. You should hear sound from your speakers.
If not, recheck all settings and wiring, and read the next few pages.
Never connnect anything except an approved Rane power supply to the red thing that looks like a telephone jack on the
rear of the unit. This is an AC input and requires special attention if you do not have a power supply exactly like the one
originally packed with your unit. See the full explanation of the power supply requirements elsewhere in this manual.
WEAR PARTS: This product contains no wear parts.
Produktspezifikationen
| Marke: | Rane |
| Kategorie: | Mischer |
| Modell: | AP 13 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Rane AP 13 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Mischer Rane
6 Juli 2025
6 Juli 2025
6 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
Bedienungsanleitung Mischer
- Soundcraft
- Skytec
- Telefunken
- Sencor
- Ursus Trotter
- Nova
- Bifinet
- Tristar
- SPL
- OneConcept
- Bourgini
- Primo
- Braun
- Russell Hobbs
- Midea
Neueste Bedienungsanleitung für -Kategorien-
5 Juli 2025
25 Juni 2025
25 Juni 2025
25 Juni 2025
25 Juni 2025
23 Juni 2025
19 Juni 2025
18 Juni 2025
18 Juni 2025
18 Juni 2025