Sani-Lav 56FFL Bedienungsanleitung
Sani-Lav
Spülbecken
56FFL
Lies die bedienungsanleitung für Sani-Lav 56FFL (6 Seiten) kostenlos online; sie gehört zur Kategorie Spülbecken. Dieses Handbuch wurde von 2 Personen als hilfreich bewertet und erhielt im Schnitt 4.8 Sterne aus 1.5 Bewertungen. Hast du eine Frage zu Sani-Lav 56FFL oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/6
1
F L O O R M O U N T W A S H S TAT I O N
Operating Manual for -Person Floor Mount Stainless Steel Wash Station 3
Models 56FFL and 56FFL-0.5
of Domestic and Foreign Parts
Columbia does not recommend use with harsh chemicals.
Product Compliance
NSF/ANSI 2 Food Equipment, NSF/ANSI 61, Section 9, ASME A112.18.1/CSA B125.1
2
C O L U M B I A S P E C I F I C AT I O N S
F L O O R M O U N T W A S H S TAT I O N
800.626.2117 columbiasinks.com info@columbiasinks.com
©2021 Columbia Products
Installation Instructions
Step 1
1. Assemble legs for the 54 and 56 series. For series 58, 510 and 512 the legs are pre-assembled.
2. Place wash station sink on the leg assembly. Secure legs to bowl with hardware provided.
3. Place wash station sink at the desired location.
4. Mark the floor where the mounting holes are at the base of the legs. See illustration A.
5. Drill holes as required for mounting hardware. Hardware not included.
Step 2
1. Install Faucet to the sink using faucet mounting kit provided. We recommend using pipe thread
sealant instead of Teflon tape.
2. Install strainer assembly to the drain hole.
3. Connect hot and cold water supply lines (not included) to the back of faucets.
Step 3
1. Position wash station sinks to pre-drilled holes and secure sink to the floor.
2. Connect waste line or drain pipe to the strainer assembly. Not included.
3. Connect water supply lines (Hot and Cold) to the water source. Not included.
4. Remove aerator from the spout and flush the water system.
5. Replace aerator to the spout.
6. Check for leaks and tighten connections if necessary.
Step 4
1. Seal gap between bowl and leg assembly as shown in illustration B.
2. When mounting against wall, it is recommended sealing the top of the backsplash to wall as
shown on illustration C.
Parts List
(1) Floor mount wash station
(1) Leg assembly set
(6) Nuts, bolts and washers for leg assembly
(4) Washers and nuts for connection sink to leg assembly set
(3) 8” on center faucet
(3) Faucet mounting kit
(1) Strainer assembly with basket
Trouble Shooting Guide
Problem Possible Cause To Diagnose Remedy
Water drips
from the spout
or from under
the lever.
1. Seat washer is worn
2. Seat is worn
3. O-rings are worn
Shut cold water source
off. See if water still leaks
from the spout. If leaks
continues repair hot side
if not repair cold side.
Recommend
installing hot
or cold faucet
repair kit.
Go to for more information on replacement parts and installation videos.columbiasinks.com
WARNING: This product can expose you to chemicals including Chromium (hexavalent compounds),
Lead, and Phthalates (DEHP) which are known to the State of California to cause cancer and birth defects
or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
NOTE: Lead content originates from Brass components in valves and faucets and is certied under
NSF/ANSI 372 as containing less than 0.25% lead in wetted surfaces.
Notice for California Consumers
Tools Required
Tape measure
Adjustable wrench
Drill motor and drill bits
Pipe wrench
Level
Safety glasses
Screw drivers: phillips and standard
Pencil
Socket wrench
Illustration A
Illustration B
Illustration C
3
C O L U M B I A S P E C I F I C AT I O N S
F L O O R M O U N T W A S H S TAT I O N
800.626.2117 columbiasinks.com info@columbiasinks.com
©2021 Columbia Products
1.5” (38mm)
20” (508mm)
2” (51mm)
60” (1524mm)
30” (762mm)
57” (1448mm)
30” (762mm)
20”
(508mm)
16.5”
(407mm)
10”
(254mm)
8” (203mm)
27” (686mm)
1.5” (38mm)
2” (51mm)
1.5” (38mm)
35” (889mm)
floor to rim
height
6”
(152mm)
6”
(152mm)
8”
(203mm)
8”
(203mm)
12”
(305mm)
8”
(203mm)
12”
(305mm)
6.75” (171mm)
.875” (22mm)
dia. holes (6)
Hole Configurations
Front Side
Top
7.5” (191mm)
45º
2.875” (73.02mm)
.75” (20mm)
10.25”
(267 mm)
mounting holes
9” (228.6mm)
on center
2” drain hole
.5” R
(12.7mm)
.5” R
(12.7mm)
49.625” (1260.5mm)
Floor Mounting DetailFloor Mounting Detail
.5” dia. Floor
Mounting Holes
9” on Center
1.5” Leg
Thickness
.75” From
Edge of Leg
to First Hole
Supply Line Detail
Back Splash
1/2” Male NPT
Hot
from Wall
Cold
from Wall
Produktspezifikationen
| Marke: | Sani-Lav |
| Kategorie: | Spülbecken |
| Modell: | 56FFL |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Sani-Lav 56FFL benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Spülbecken Sani-Lav
12 Juni 2025
12 Juni 2025
12 Juni 2025
11 Juni 2025
11 Juni 2025
11 Juni 2025
11 Juni 2025
11 Juni 2025
11 Juni 2025
11 Juni 2025
Bedienungsanleitung Spülbecken
- Deante
- Rangemaster
- Caple
- Gustavsberg
- Tot Mate
- Cookology
- Stern-Williams
- Sloan
- Atosa
- Krowne
- Foster
- Eagle Group
- Artusi
- CDA
- Smeg
Neueste Bedienungsanleitung für -Kategorien-
20 Juni 2025
19 Juni 2025
17 Juni 2025
12 Juni 2025
12 Juni 2025
11 Juni 2025
11 Juni 2025
11 Juni 2025
11 Juni 2025
11 Juni 2025