SkyRC PC2500 Bedienungsanleitung
Lies die bedienungsanleitung für SkyRC PC2500 (2 Seiten) kostenlos online; sie gehört zur Kategorie Ladegerät. Dieses Handbuch wurde von 28 Personen als hilfreich bewertet und erhielt im Schnitt 4.8 Sterne aus 14.5 Bewertungen. Hast du eine Frage zu SkyRC PC2500 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/2
Customizable for CAN communication
Maximum Output Power of 2500W
English & Chinese switchable UI
Battery Voltage Meter
1
2
CH 39%1 05:18
CHG
3. 83 3. 82 3.83 3. 83
3. 83 3. 83 3. 823. 82
3. 82 3. 82
0. 00 0. 00
3. 83
3. 83
LiPo
3
20A
45.9V
中⽂
ENGLISH
After choosing the desired
language, press and hold
the START button to confirm.
32%
45.0A
78mAh
FAST
LiPo
45.6V
1
1
2
3
4
DONE
CHARG
100%
78%
53%
29%
12S
LiPo
Battery
12S
LiPo
Battery
32%
5.9A
78mAh
LiPo
45.6V
1
28%02:28
3.80 3.80 3.80 3.80
3.80 3.80 3.803.80
3.80
3.80
0.00 0.00
3.80
3.80
LiPo
CH1
FAST
3.74 3.74 3.74 3.74
3.74 3.74 3.743.74
3.74
3.74
0.00 0.00
3.74
3.75
LiPo
SETTING
WATTING...
3.74 3.74 3.74 3.74
3.74 3.74 3.743.74
3.74
3.74
0.00 0.00
3.74
3.75
LiPo
CH1
STO
SETTING
WATTING...
STO
CH1
STO DONE...
Long-press the START button for
three seconds to start
If a Lithium battery will not be used for a long time, it's highly recommended to charge or discharge the single-cell battery
to 3.8V±0.05V with the STORAGE mode to extend the battery life.
If the battery voltage is lower than 3.8V±0.05V per cell, the charger will charge it to 3.8V±0.05V per cell in the
STORAGE mode;
If the battery voltage is higher than 3.8V±0.05V per cell, the charger will discharge the battery to 3.8V±0.05V per cell in
the STORAGE mode.
Select the STORAGE mode and long-press the START button for three seconds to start maintaining the battery.
Short-press the START button to stop charging or exit any abnormal state.
BATTERY MAINTENANCE
Charging Channel
Elapsed Time
Battery Percentage
Battery Type
Total Pack Voltage
Charge Current
Charge Mode
Single Cell Voltage
Channel 1: Battery Percentage
Channel 2: Battery Percentage
Channel 3: Battery Percentage
Channel 4: Battery Percentage
Channel 1
Channel 2
Channel 3
Channel 4
Charging Channel
Battery Type
Battery Percentage
Charge CurrentCharge Mode
Support 4 packs of 12S or 14S LiPo batteries
Support 4 packs of 12S LiHV batteries
Three working modes of Fast Charge, Charge, and Storage
Maximum safety of short circuit protection, reverse polarity &
over-temperature protection
FEATURES
Handle
AC Input:
110-240V
Channel 1:
Charge and
Balance Port
LCD Display
Control Panel
Channel Button
Mode Button
Start Button
PC2500 is a smart charger that integrates CAN communication for smart batteries and ordinary lithium batteries. It
can connect four batteries at the same time. The charger's maximum output power is up to 2500W, with three modes
of Fast(Fast Charge)/Charge(Slow Charge)/Storage. The charger can recognize the batteries with customized CAN
communication instantly. Charging is convenient and straightforward with a better user experience.
Channel 2:
Charge and
Balance Port
Channel 3:
Charge and
Balance Port
Channel 4:
Charge and
Balance Port
INTRODUCTION
2500W Intelligent & Fast Quattro 12/14S Battery Charger
Instruction Manual
Version: 1.3
Heat
Dissipation
Outlet
Heat
Dissipation
Inlet
OPERATIONS
Charged Capacity
Please make sure the AC power is well-grounded before using, and strictly follow the operating procedures below:
The charger can connect up to 4 batteries.
1)Power on: Connect AC power, the charger will beep once, and the fan will start to rotate during self-check;
2)Select the language:
Initial-Use: short-press the MODE button, choose the preferred language in the interface, then press the START
button to confirm.
Routine charging: long-press the MODE button for 10 seconds to enter the language selection interface.
5) Select the Charge Mode: Fast Charge or Charge, and long-press the START button for three seconds to start
charging.
Note: 12S and 14S batteries cannot be charged simultaneously under the Charge mode; short-press the START
button to stop charging or exit this abnormal state.
3) Select the battery type: Press and hold both the MODE & START buttons simultaneously for three seconds to
select the battery type: LiPo or LiHV.
4) Connect the Battery: please follow the diagram below to connect the battery. (The charger will automatically detect
the battery cells)
CHARG
CHARG
Total Pack Voltage
Produktspezifikationen
| Marke: | SkyRC |
| Kategorie: | Ladegerät |
| Modell: | PC2500 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit SkyRC PC2500 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Ladegerät SkyRC
20 Januar 2026
16 Dezember 2025
16 Dezember 2025
16 Dezember 2025
16 Dezember 2025
15 Dezember 2025
15 Dezember 2025
15 Dezember 2025
15 Dezember 2025
15 Dezember 2025
Bedienungsanleitung Ladegerät
- Manhattan
- Panduit
- Navitel
- Cobra
- Traxxas
- Rawlink
- 4Load
- Lenmar
- CamLink
- CyberPower
- Terratec
- MSW
- Elinchrom
- Eneroid
- PDP
Neueste Bedienungsanleitung für -Kategorien-
11 Januar 2026
10 Januar 2026
10 Januar 2026
6 Januar 2026
4 Januar 2026
4 Januar 2026
2 Januar 2026
30 Dezember 2026
30 Dezember 2026
8 Dezember 2025