Speco Technologies O4DT1 Bedienungsanleitung
Lies die bedienungsanleitung für Speco Technologies O4DT1 (11 Seiten) kostenlos online; sie gehört zur Kategorie Sicherheitskamera. Dieses Handbuch wurde von 49 Personen als hilfreich bewertet und erhielt im Schnitt 5.0 Sterne aus 25 Bewertungen. Hast du eine Frage zu Speco Technologies O4DT1 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/11
Quick Start Guide
4MP Turret IP Camera
O4DT1
Version 1.0.0
i
Welcome
Thank you for purchasing this network camera!
This manual is designed to be a reference guide for the product .
Please read this manual carefully before operang the unit and retain it for future reference.
Should you require any technical assistance, please contact Speco Technologies Technical Support.
ii
Important Safeguards and Warnings
1 Electrical safety
．
．
．
．．
All installaon and operaon here should conform to local electrical safety codes.
Use a cered/listed 12VDC Class 2 power supply only.
Please note: Do not connect two power supplying sources to the device at the same me; it may
result in device damage! The product must be grounded to reduce the risk of electric shock.
Improper handling and/or installaon could run the risk of re or electrical shock.
2 Environment
．
．
．
．．
Heavy stress, violent vibraon or exposure to water is not allowed during transportaon, storage
and installaon.
This product should be installed in a cool, dry place away from direct sunlight and heat sources.
Do not install the product in extreme temperature condions.
Do not expose the camera to electromagnec radiaon. Otherwise it may result in CMOS sensor
failure.
Do not block any venlaon openings.
Do not allow water and liquid intrusion into the camera.
3. Operaon and Daily Maintenance
Please shut down the device and then unplug the power cable before you begin any maintenance
work.
Do not touch the CMOS sensor opc component. You can use a blower to clean the dust on the
lens surface.
Always use the dry so cloth to clean the device. If there is too much dust, use a cloth dampened
with a small quanty of neutral detergent. Finally use the dry cloth to clean the device.
Please use a professional opcal cleaning method to clean the enclosure. Improper enclosure
cleaning (such as using cloth) may result in poor IR funconality and/or IR reecon.
The grounding holes of the product are recommended to be grounded to further enhance the
reliability of the camera.
Dome cover is an opcal device, please don’t touch or wipe cover surface directly during
installaon and use, please refer to the following methods if dirt is found:
Stained with dirt
Use oil-free so brush or hair dryer to remove it gently.
Stained with grease or ngerprint
Use oil-free coon cloth or paper soaked with alcohol or detergent to wipe from the lens center
outward. Change the cloth and wipe several mes if it is not clean enough.
Produktspezifikationen
| Marke: | Speco Technologies |
| Kategorie: | Sicherheitskamera |
| Modell: | O4DT1 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Speco Technologies O4DT1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Sicherheitskamera Speco Technologies
8 Juni 2025
6 Juni 2025
14 August 2024
26 Mai 2024
26 Mai 2024
22 Mai 2024
21 Mai 2024
19 Mai 2024
16 Mai 2024
Bedienungsanleitung Sicherheitskamera
- Swisstone
- Dedicated Micros
- Kwikset
- Uniden
- Lutec
- Wanscam
- EMOS
- Arlo
- Boss
- Hollyland
- Alfatron
- Aritech
- Ednet
- I-Onik
- EVOLVEO
Neueste Bedienungsanleitung für -Kategorien-
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
14 Juni 2025
14 Juni 2025