SYBA Multimedia SY-ENC35028 Bedienungsanleitung
SYBA Multimedia
Nicht kategorisiert
SY-ENC35028
Lies die bedienungsanleitung für SYBA Multimedia SY-ENC35028 (10 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 42 Personen als hilfreich bewertet und erhielt im Schnitt 4.7 Sterne aus 21.5 Bewertungen. Hast du eine Frage zu SYBA Multimedia SY-ENC35028 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/10
SY-ENC35028
3.5” 2-BAY RAID Storage Enclosure
User Manual
1 Introduction
1.1 Features
-Supports JBOD, RAID0,RAID1,Normal mode
-Enhanced data protection and high -performance storage
-Automatic disk rebuild (Under SAFE Mode)
-Supports USB3.0 high speed to reach 5.0Gbps
-Supports Plug-play and Hot-plug
-Supports mode select via jumper setting
1.2 Specications
Inner Interface: SATA
Outer Interface:USB3.0
Date Transfer rate: Support USB 3.0 super-speed (5Gbps),
Complies with USB 2.0 high speed (480Mbps),USB 1.1 Full speed ( Mbps) 12
Suitability: 2 x 3.5” SATA I/II/III HDD
· USB cable
· Manual
2 RAID Function
What is RAID?
RAID (Redundant Array of Independent Disks) is a set of technology
standards for teaming disk drives to improve fault tolerance and performance
Why RAID?
Increased data protection. If in an unfortunate event where a drive fails,
the same data is preserved on the mirrored drive.
Intelligent array controllers can apply dierent types of RAID for different
hard disk drives.
Increased overall network system data capacity.
Increased I/O read/write ecienc y.
Changing the RAID Mode:
The RAID mode should be set before installing the drives and then rst
formatting the drives.
1. Make sure the power is o.
2. Set the RAID switch and select your preferred RAID mode. There are 2
mode switch on the inner panel of the product. 4 alternate arrays can be es
created through these 2 switches. View the diagram below to see the
dierent conguration settings for the RAID switches:
3. Install the hard drives and turn on the power.
4. Format the drives.
5. Done
Note: Changing the RAID mode will require you to re-format the drivers. Make
sure to backup all existing data rst!
※
※
※
※※
Normal Mode (Non-Raid):
Normal mode is the default setting of HDD enclosure, and will not use any
RAID mode. In Normal mode, both of the two hard disks inside the enclosure
are in independent operation state, and also will be identied as two an
separate drives in the system explorer. Users can choose any hard drive for
storing les. If one hard drive is damaged, the other hard drives data will not be
aected.
※
※
※
※※
JBOD Mode (Spanning):
In JBOD mode two hard drives will be merged into one. Performance and
literacy speed will be the same as a single hard drive. The total capacity of the
portable hard drive is equal to the sum of the two hard drives combined When .
writing data to the JBOD array, the system will write date to the first disk. When
the storage space of the rst disk is full the data will start be stored on the
second disk. If the data in the rst disk is damaged, then all data in the array
Produktspezifikationen
| Marke: | SYBA Multimedia |
| Kategorie: | Nicht kategorisiert |
| Modell: | SY-ENC35028 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit SYBA Multimedia SY-ENC35028 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert SYBA Multimedia
21 März 2024
Bedienungsanleitung Nicht kategorisiert
- ResMed
- Geratherm
- Ordex
- Kemo
- Etekcity
- Blebox
- Profizelt24
- Ditek
- Ardo
- Waldbeck
- Klein Tools
- Elektra Bregenz
- Finnlo
- VintageView
- Jamo
Neueste Bedienungsanleitung für -Kategorien-
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025