TK Audio M/S Station Bedienungsanleitung

Lies die bedienungsanleitung für TK Audio M/S Station (5 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 40 Personen als hilfreich bewertet und erhielt im Schnitt 4.1 Sterne aus 8 Bewertungen. Hast du eine Frage zu TK Audio M/S Station oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

M/S Staon

Advanced M/S tool

www.tkaudio.se

The M/S Staon is a new mastering and main bus tool with four separate funcons divided into two sec-

ons including an advanced cue funcon.

Secon 1 is a parallel insert with M/S funcon allowing the user to use separate blend controls for the mid

and side signals. For maximum precision the blend control(s) has 16 posions from dry to wet.

Secon 2 consists of three parts, an ellipcal EQ with 16 frequencies, a width control from 0-200% and an

advanced cue funcon.

The two secons are normally linked internally but can be used separately with their own balanced inputs

and outputs by removing four jumpers inside the unit (see unlink secon 1 and 2). This way you can use

them at dierent locaons in your setup.

Parallel insert with M/S funcon:

With the insert secon you can insert an external

processor like an EQ, compressor, distoron unit

etc, and then dial in a mix between the processed

signal (wet) and the unprocessed signal (dry).

For maximum precision the blend control has 16

steps from dry to wet.

If you acvate the M/S funcon your signal will

be coded into mid ( L+R ) and side ( L-R ). The mid

signal normally contains all the center info such

as bass, kick drum, lead vocal etc and the side

signal contains all the panned parts of the signal.

In M/S you can process the mid signal and side

signal separately with dierent types of proces-

sors and the blend controls is placed infront of

the M/S encoder before it’ decoded back to le

and right signals.

With the blend split funcon you get separate

blend controls for the mid and side signal.

Ellipcal Equalizer:

With the ellipcal EQ all frequencies below a

selected frequency will be made to mono. This

funcon can make your low end more focused.

It’s an old technique used when mastering for

vinyl.

Too much low end in the side channel (vercal)

can make the needle bounce slightly and cause

distoron.

By using a 12dB high pass lter in the side chan-

nel you set the frequency under which the signal

will be processed as mono. As a HPF introduces

phase shi to the signal, a phase correcon

is added to the mid channel keeping channel

separaon as good as possible. The EEQ has 16

frequencies from 36Hz to 302Hz.

With the EEQ cue funcon you can monitor the

signals that are mixed between the channels.

Produktspezifikationen