Totolink EX200 Bedienungsanleitung
Totolink
WLAN-Repeater
EX200
Lies die bedienungsanleitung für Totolink EX200 (1 Seiten) kostenlos online; sie gehört zur Kategorie WLAN-Repeater. Dieses Handbuch wurde von 29 Personen als hilfreich bewertet und erhielt im Schnitt 4.8 Sterne aus 15 Bewertungen. Hast du eine Frage zu Totolink EX200 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/1
For more information, please go to www.totolink.net
Product Introduction
Method One: Quick Setup by Smart Phone
FAQ(Frequently Asked Questions)
Method Two: Wi-Fi Extension by WPS Button
Power on. Plug the device into any wall
socket that near the router. Wait until the
System LED blinks slowly.
1Press WPS button on Extender for about 2 seconds.
3
SSID: TOTOLINK_EX200
The Extend LED flash when
connecting and turns to solid
light when connected
Press WPS button on your router for about 2 seconds.
2
RST/WPS
Wi-Fi: Upper router’s SSID and password
The Extend LED turns to solid light, Wi-Fi extension successful. Please refer to to place the Extender.Relocate
4
EX200's default Network Name (SSID) is TOTOLINK_EX200 (no encryption).
With success repeater connection, this SSID (TOTOLINK_EX200) will change
to the same SSID (with same encryption) of upper Router/AP. After deployment,
just connect to the Router/AP's SSID. Congratulations, you have extended your
WiFi coverage successfully.
What should I do if I cannot access the extender’s web management
page?
A1: Make sure you have connected to the wireless network name of
the extender.
A2: Open any browser, enter 192.168.0.254 in the address bar and
press Enter.
A3: Reset the extender and connect to it again.
1
How to reset the extender to factory default settings?
Keep the extender power on, use a pin to press the RST button
on the bottom of device. When both System and Extend LED blinks,
release the button. The device will restore to factory default settings.
2
Quick Installation Guide
Wireless N Range Extender
Model No.: EX200
V1.0 | 1712
Information in this document is subject to change without prior notice.
Copyrights TOTOLINK. All rights reserved. Website: http://www.totolink.net
On: The device is starting up or waiting for
extending.
Slow-blinking: The device is working normally.
Quick-flashing: The device is to restart.
Off: The device is power off.
On: Extending successfully.
-Good; -Normal; -Bad.Green Yellow Red
Slow-blinking: The device is extending to
upper Router/AP.
Quick-flashing: The device is to restart.
Off: No extending.
WPS: Press the button for about 2-3 seconds
to enable WPS.
LAN port: This port is used to connect to PC.
RST: Press the button for about 10 seconds, the
device will restore to factory default settings.
RST
Power on. Plug the device into any wall
socket that near the router. Wait until the
System LED blinks slowly.
1Connect to the Extender. Using your
smart phone to search Wi-Fi
TOTOLINK_EX200. (Settings—Wi-Fi)
2Login. The Setting page will turn up automatically.
Click . If below window doesn’tExtender Mode
appear, please open a browser and enter
192.168.0.254 manually.
3Extend Wi-Fi. Wait for a while, the Extender
auto-detects APs nearby. Choose your
router’s 2.4GHz SSID.
4 6 Verify. Check the LED status to verify
whether the Wi-Fi extension is
successful.
Configure . Enter its wireless password. Either keep
the default SSID or customize it for extended 2.4GHz
wireless network. Verify your settings and click Connect.
5
Relocate
Horizon Line
Host Network Extended Network
Vertically place the Extender
Wall Socket
Plug the extender into wall socket that halfway between your
router and the Wi-Fi dead zone. Wait about 30 seconds until
the Extend LED light turns solid green or yellow. If not, please
relocate it closer to your router to achieve better signal quality.
1
In order to make full use of extender, please keep the antennas
of the extender perpendicular to the horizontal plane. See blow:
2
Produktspezifikationen
| Marke: | Totolink |
| Kategorie: | WLAN-Repeater |
| Modell: | EX200 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Totolink EX200 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung WLAN-Repeater Totolink
29 September 2024
28 September 2024
9 August 2024
1 August 2024
26 Juli 2024
Bedienungsanleitung WLAN-Repeater
- Barox
- Siig
- TP-Link
- DSC
- Devolo
- Cisco
- Mikrotik
- Xiaomi
- Strong
- Lindy
- Digitus
- Netgear
- Axis
- Crestron
Neueste Bedienungsanleitung für -Kategorien-
13 Juni 2025
9 Juni 2025
9 Juni 2025
3 Juni 2025
31 Mai 2025
2 Dezember 2024
25 November 2024
10 Oktober 2024
3 Oktober 2024
30 September 2024