TRENDnet TC-NT3 Bedienungsanleitung


Lies die bedienungsanleitung für TRENDnet TC-NT3 (11 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 62 Personen als hilfreich bewertet und erhielt im Schnitt 4.6 Sterne aus 31.5 Bewertungen. Hast du eine Frage zu TRENDnet TC-NT3 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Seite 1/11
TC-NT3(V1) /10.30.2014
TC-NT3
VDV & USB Cable Tester
ENGLISH
1
Remote Terminator
1
USB 2.0/3.0 Port Network/Phone Port
USB 2.0/3.0 PortNetwork/Phone Port
LED Indicators
Test Button
Power On/Off
Switch
Active Network
Link LED
Mode Selection
Button
Transmitter
Getting to know TC-NT3
ENGLISH
Slide the bottom of the TC-NT3 Remote Terminator towards the back of
the TC-NT3 Transmitter.
1. Change the battery if the Battery Low ( ) LED is on. B/L
2. Slide the battery cover off the TC-NT3 transmitter.
3. Connect and insert the battery.
4. Slide the battery cover back on to the TC-NT3 remote transmitter.
How to Separate the Transmitter and Terminator
Install / Replace the Battery (9V Alkaline battery is not included)
Warning and Caution
1. This device is designed to be used on a cabling system without voltage. Do not
connect the TC-NT3 to any live circuits, lines or outlets. Doing so may damage
the TC-NT3 and equipment.
2. Disconnect cables from all electronic equipment with voltage before testing.
Failure to do so may damage the TC-NT3.
2


Produktspezifikationen

Marke: TRENDnet
Kategorie: Nicht kategorisiert
Modell: TC-NT3

Brauchst du Hilfe?

Wenn Sie Hilfe mit TRENDnet TC-NT3 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten