Uline H-10903 Bedienungsanleitung

Lies die bedienungsanleitung für Uline H-10903 (18 Seiten) kostenlos online; sie gehört zur Kategorie Waage. Dieses Handbuch wurde von 2 Personen als hilfreich bewertet und erhielt im Schnitt 4.0 Sterne aus 3 Bewertungen. Hast du eine Frage zu Uline H-10903 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

PAGE 1 OF 18 0825 IH-7935

ALL-WEATHER

LOW PROFILE

FLOOR SCALE

1-800-295-5510

uline.com

H-7935, H-7936, H-9672

H-9673, H-10903, H-10904

INTRODUCTION

INTRODUCTION

SITE SELECTION

Select a site for the floor scale where it is least likely to

be damaged by forklifts and other material handling

devices. Floor scale load cell weighing elements are

prone to overload damage caused by side impacts,

falling objects and weight loads that exceed the rated

capacity of the scale.

Site should be:

• Level within 1/4".

• Free from vibration.

• Clean of debris.

• Out of the way of vehicle traffic patterns, unless

installed in a pit while having a rated capacity

that exceeds all loaded vehicle weights that could

possibly drive onto or contact the scale.

The cable from the floor scale to the digital weight

indicator should be run through conduit to protect it

against possible damage. Running the instrument cable

through conduit is the best method of protection.

UNPACKING

1. Inspect your shipment for damage. If you see visible

signs of damage, notify carrier at once.

2. Remove floor scale from the shipping pallet.

3. Unpack the digital indicator. Digital indicator and

power cord are located in the junction box in the

side of the scale. (See Figure 2)

RAMP INSTALLATION (OPTIONAL)

1. Set floor scale in a desired location.

2. Position ramp on desired side of the scale. There

should be 1/8 – 1/4" gap between the scale and

ramp. (See Figure 1)

3. To hold ramp in place, drill 1/2 x 3" anchors (not

included) through ramp’s mounting tabs into the

floor.

NOTE: Scale and ramp should not be touching.

Contact will impede scale from weighing

accurately.

HEIGHT AND LEVEL ADJUSTMENTS

1. Unlock the locknuts on all four feet.

2. Using a pry bar, lift the weight of the scale base off

the scale feet.

3. Make adjustments by screwing the feet

counterclockwise. All four feet should make firm

contact with the floor.

4. Do not screw feet counterclockwise more than ten

turns.

5. Tighten locknuts on feet.

6. Check your work.

Para Español, vea páginas 7-12.

Pour le français, consulter les pages 13-18.

Figure 1

RampScale

Anchor goes here

Mounting Tabs

Produktspezifikationen