Vemer CO Sensor Bedienungsanleitung

Seiten 1 Engels Nicht kategorisiert

Lies die Bedienungsanleitung für Vemer CO Sensor kostenlos online oder lade das PDF herunter. 35 Personen fanden diese Anleitung hilfreich. Frage zu diesem Modell? Stelle eine Frage

PDF herunterladen (0.3 MB) Technische Daten

V3IS00462-010

CH4 SensorCO SensorLPG Sensor, and areprobesforthedetectionof

methanegas,carbonmonoxideandLPGtobeconnectedtoSRG and SRG.4

controlunitstocreatesystemsfordetectinggasinareassuchasboilerrooms,

warehouses,etc.

It is wall-mounted in a vertical position using screws and plastic plugs.

SAFETY WARNINGS

During installation and operation of the instrument, comply with the

following instructions:

1) The device must be installed by a competent person

2) Before removing the cover, make sure that power is NOT provided to

the device

3) Before accessing the terminals, make sure that the electrical leads are

not live

4) Install the detector in the correct position (see “Installation”)

5) Do not power on the device if any part of it is damaged

Code Model Description

VE205100CH4SENSOR Methanedetectionsensor

VE206900 LPG SENSOR LPG sensor

VE207700 CO SENSORCarbonmonoxidesensor

TECHNICAL CHARACTERISTICS

• Powersupply:fromthecontrolunitSRGorSRG.4

 −Currentinput(at6.5V):40mA

 −Connection:terminalsof2.5mm2C(common),S(signal),A(powersupply)

• Modelsandcalibration:

 −Methanegas:CH4Sensor,(default)10%LIEofmethane

 −LPG:LPGSensor,(default)12%LIEofisobutene

 −Carbonmonoxide:COSensor,(default)200ppmofcarbonmonoxide

• Max.lengthofconnection:50m

• Container:inself-extinguishingplasticmaterial

• Fastenedtowallusingscrewsandplasticplugs

• Protection:IP30

• Operatingtemperature:0÷+50°C

•Humidity: 90%R.H.withoutcondensation≤

INSTALLATION

 LPG,COandCH4Sensorsaredesignedtobewall-mounted(vertically),using

screwsandplasticplugs.Toproceedwithinstallation,openthecontainerby

unscrewingthescrewlocatedonthelowerside.Makesurenottodamagethe

sensorandnottotouchthecalibrationdevices.

POSITIONING

 Thecorrectinstallationoftheprobeisessentialtoproperoperationofthe

system.Therefore,itmustbeinstalled:

• Inareaswithcirculationofnaturalair;

• Inareasthatarenotsubjecttodustordirtthatmayrenderthesensor

inoperative;

• Nearjetsofwater,intakegrilles,openings,etc.

• Atanadequatedistancefromusersofgassoastopreventthesystemfrom

interveningimproperlyduetofunctionalleakage.

 Also,positioningdependsonthetypeofgastobedetected,specically:

• CH4 Sensor: Methane gas – at top, about 20-30 cm from the ceiling

• LPG Sensor: LPG – at bottom, about 20-30 cm from the ﬂoor

• CO Sensor: carbon monoxide – about 1.5 m from the ﬂoor

 Fornewsystems,theprobemustbeinstalledaslateaspossible,sothattypical

constructionsiteactivitiesdonotdamagethedetector.

CONNECTIONS

 Normalelectricalcablescanbeusedforconnections.Inanycase,when

installationisinplacesthatarestronglyexposedtoelectromagnetic

disturbances,itisadvisabletouseshieldedcables.Thedetectionsystemmust

alwaysbeinoperation.Therefore,theelectricalpowersupplyofthedetector

mustnotincludeswitchesorotherdevicesthatmayaccidentallyshutitoff.The

averagelifespanoftheprobesis5yearsfromthedateofinstallation.Therefore,

attheendofthattimetheywillneedtobereplaced.

Note. Make sure you check operation at least once a year, and in any

case whenever there is an extended period of disuse or in the event of

replacement. Any tampering may compromise correct operation of the

system.

REFERENCE STANDARDS

CompliancewithCommunityDirectives:

2006/95/EC (lowvoltage)

89/336/EECmod.from andfrom92/31/EEC 93/68/EEC(E.M.C.)

isdeclaredwithreferencetothefollowingstandards:

EN 61779-4, EN 50270

User Manual

SENSORS FOR SRG/SRG.4 CONTROL UNITS

Read all the instructions carefully

Dimensions

Connection diagrams

119,0

75,3

36,0

CH4 SENSOR

C SA

SRG/SRG.4

Mod. CH4 SENSOR

Mod. LPG SENSOR

Mod. CO SENSOR

Bewerten Sie dieses Handbuch

Produktspezifikationen

Marke:	Vemer
Kategorie:	Nicht kategorisiert
Modell:	CO Sensor

Brauchst du Hilfe?

Wenn Sie Hilfe mit Vemer CO Sensor benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten

Bedienungsanleitung Nicht kategorisiert Vemer

Vemer MCR048 Bedienungsanleitung Vemer Multitest VE 100 SII Bedienungsanleitung Vemer Klio fancoil Bedienungsanleitung Vemer PR-1DA Bedienungsanleitung Vemer EVM-R Bedienungsanleitung Vemer ADR-D 230 D22 Modbus Bedienungsanleitung Vemer ES Bedienungsanleitung Vemer HC-MM Bedienungsanleitung

Beliebt in Nicht kategorisiert

Vemer TDMU Bedienungsanleitung Vemer Simply D Bedienungsanleitung Vemer EST Bedienungsanleitung